Ripcord PlusPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Direction for Use
RIPCORD PLUS has residual activity. The contents of this bottle will make up 25 litres of spray mix. Invert the container several times before opening. Mix 40 ml RIPCORD PLUS per litre of clean water. Apply as a fine droplet surface spray using one litre of prepared spray mix per 20 m2 of surface area. Apply to wet the surface but not to the point where the spray collects in drips and runs off. A higher volume of spray may be required on very absorbent surfaces such as brick or cement. If the spray job is interrupted, agitate the spray mix before re-use. Do NOT store the spray mix. Prepare fresh spray mix as necessary. When there is a concern about the possible effect of RIPCORD PLUS on the surface to be treated, such as new paint work, a small test area should be sprayed first to check compatibility.

Where to Apply
Ants - spray nests, runs, walls and places where ants are seen. Cockroaches - spray walls, skirting boards, cupboards, and behind sinks, stoves and pipes. Pay particular attention to cracks and crevices. Flies and Mosquitoes - spray walls, ceilings, windowsills and other sheltered areas and exposed surfaces. Fleas, silverfish, slaters, carpet beetles - spray skirting boards, floors, carpet, kennels, bedding and adjacent wall area. DO NOT USE ON PETS. Common House Borer - apply by brush or spray uninfested wooden joinery, cupboards, doors, skirting, and furniture. For the treatment and protection of UNINFESTED timber only. Spiders - spray nests, hiding places and exposed surfaces. Animal Housing Areas - spray sheltered areas/exposed surfaces for nuisance and biting flies. Use a higher rate of 70 ml per litre of water when pest numbers are very high or when treated surfaces are exposed to the weather.

Important
Evacuate premises to be sprayed. The premises may be re-occupied as soon as spray applications are dry. Before spraying remove pets and cover or remove fish tanks and bird cages. Do NOT spray on or allow spray to land on personal contact items e.g. clothing, footwear, towels or bedding. Do NOT allow spray to contact food, food preparation surfaces or food utensils. Remove or cover all foodstuffs before spraying. Wash all food contact surfaces thoroughly before reintroducing any foodstuffs. Do NOT use where food packaging materials (carton, liners etc.) are stored or assembled. Do NOT use near air vents or ducts in food stores or processing plants while they are in operation.

Insecticide Resistance Warning
Some naturally occurring biotypes resistant to RIPCORD PLUS and other synthetic pyrethroid insecticides may exist through natural genetic variability in any insect population. The resistant individuals can eventually dominate the insect population if RIPCORD PLUS and other synthetic pyrethroids are used excessively. The effectiveness of RIPCORD PLUS on resistant individuals could be significantly reduced. Since occurrence of resistant individuals is difficult to detect prior to use, BASF New Zealand Limited accepts no liability for any losses that may result from the failure of RIPCORD PLUS to control the resistant insects. RIPCORD PLUS may be subject to specific resistance management strategies. For further information contact your local supplier or BASF New Zealand Limited representative.

Handling
This product must be under the personal control of an APPROVED HANDLER when applied in a wide dispersive manner or used by a commercial contractor.

Transport
Do NOT carry on a passenger service vehicle.

Spillage
Prevent further spillage and product from entering waterways. Wear overalls, gloves, footwear, facemask or goggles. Absorb spill with an inert absorbent material (e.g. vermiculite) and place in sealable container for disposal. Wash affected area with water and alkaline detergent. Absorb and collect washings and place in the same sealable container as the spilled material. Dispose of the waste safely in an approved landfill.

Personal Protection
When mixing and preparing spray, wear cotton overalls buttoned to the neck and wrist, a washable hat, suitable gloves, and goggles or a face shield.

General Safety and Hygiene Measures
Avoid contact with skin, eyes and clothing, and inhalation of spray mist. Do NOT eat, drink or smoke while using this product. Remove protective clothing and wash hands and exposed skin after spraying and before eating, drinking, smoking or using the toilet. Wash the outside of gloves before removing. Wash protective clothing immediately after use. Keep and wash work clothing separately from other laundry.

Use
Remove pets. Apply with well-maintained and accurately calibrated spray equipment designed to produce fine spray droplets. Toxic to bees (insecticide). Spray must not contact plants in flower if they are likely to be visited by bees. Do NOT allow spray drift outside the target area to occur. Do NOT spray over, or allow drift over, surface water. Clean out the sprayer thoroughly after use. Do NOT contaminate water when disposing of equipment wash waters.

Record Keeping
Records of use must be kept if using more than 3L within a 24 hour period.

Note
Storage, application and record keeping must be as described in the current version of the New Zealand Standard for the Management of Agrichemicals NZS8409.

First Aid
If swallowed, do NOT induce vomiting. For advice contact the National Poisons Centre 0800 POISONS (0800 764 766) or a doctor immediately. If skin or hair contact occurs, remove contaminated clothing and flush skin and hair with running water. Do NOT scrub the skin. If splashed in eyes, wash out immediately with water.

Storage
Store in original container, tightly closed, away from foodstuffs, and out of direct sunlight. Stores containing more than 100 litres require emergency response plans and secondary containment systems, and are subject to signage.