Bravo UltrexComparación de productos fitosanitariosComparación de productos fitosanitariosNotificar inexactitudesNotificar inexactitudes

DECONTAMINATION AND DISPOSAL
For information on disposal of unused, unwanted product, contact the manufacturer or the provincial regulatory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill, and for clean up of spills.

BAG DISPOSAL:
1. Empty bag thoroughly into spray tank.
2. Make the empty bag unsuitable for further use.
3. Dispose of the bag in accordance with provincial requirements.

PRODUCT INFORMATION
BRAVO ULTREX is an excellent fungicide when used according to label directions for control of a broad spectrum of plant diseases. BRAVO ULTREX is recommended for use in programs which are compatible with the principles of Integrated Pest Management (IPM), which include the use of disease resistant crop varieties, cultural practices, pest scouting and disease forecasting systems which reduce unnecessary applications of pesticides.
BRAVO ULTREX is effective for strategic use in programs that attempt to minimize disease resistance to fungicides. Some other fungicides which are at risk from disease resistance exhibit a single-site mode of fungicidal action. BRAVO ULTREX, with a multi-site mode of action, may be used to delay or prevent the development of resistance to single-site fungicides. Please refer to the Resistance Management Recommendations section of this label for more information.
BRAVO ULTREX can be used effectively in dilute or concentrate sprays. Thorough, uniform coverage is essential for disease control.
General Precautions and Restrictions
DO NOT combine BRAVO ULTREX in the spray tank with other pesticides, or surfactants or fertilizers, unless recommended on this label. DO NOT combine BRAVO ULTREX with Dipel† as phytotoxicity may result from the combination when applied to some crops on this label.

DIRECTIONS FOR USE
APPLICATION
Rates on this label indicate kilograms of BRAVO ULTREX per hectare, unless otherwise stated. Under conditions favoring disease development the high rate specified and shortest application interval should be used.
The required amount of BRAVO ULTREX should be added slowly into the spray tank during filling. With concentrate sprays, pre-mix the required amount of BRAVO ULTREX in a clean container and add to the spray tank as it is being filled. Keep agitator running when filling spray tank and during spray operations.
Apply BRAVO ULTREX in sufficient water to obtain adequate coverage of foliage. Spray volume to be used will vary with crop and amount of plant growth. For field and row crops, spray volume usually will range from 200 L to 1400 liters per hectare for dilute sprays and 50 to 100 liters per hectare for concentrate ground sprays and aircraft applications. For tree and orchard crops, apply BRAVO ULTREX in sufficient water and with proper calibration to obtain uniform coverage of tree canopy. For fruit and nut bearing crops, the maximum volume is 2800 L per hectares unless indicated otherwise in the specific use directions. For conifers, the maximum volume is 1000 L per hectare.
Generic Aerial Application Label Instructions
Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rates and conditions of this label.
Label rates, conditions and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. When no rate for aerial application appears for the specific use, this product cannot be applied by any type of aerial equipment.
Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking devices.
Use Precautions
Apply only when meteorological conditions at the treatment site allow for complete and even crop coverage. Apply only under conditions of good practice specific to aerial application as outlined in the National Aerial Pesticide Application Manual, developed by the Federal/Provincial/Territorial Committee on Pest Management and Pesticides.
Do not apply to any body of water. Avoid drifting of spray onto any body of water or other nontarget areas. Specified buffer zones should be observed.
Coarse sprays are less likely to drift, therefore, avoid combinations of pressure and nozzle type that will result in fine particles (mist). Do not apply during periods of dead calm or when wind velocity and direction pose a risk of spray drift. Do not spray when the wind is blowing towards a nearby sensitive crop, garden, terrestrial habitat (such as shelter-belt) or aquatic habitat.
Operator Precautions
Do not allow the pilot to mix chemicals to be loaded onto the aircraft. Loading of premixed chemicals with a closed system is permitted.
It is desirable that the pilot have communication capabilities at each treatment site at the time of application.
The field crew and the mixer/loaders must wear chemical resistant gloves, coveralls and goggles and a NIOSH approved dust/mist filtering respirator (MSHA/NIOSH approval number prefix TC- 21C) during mixing/loading, cleanup and repair. Follow the more stringent label precautions in cases where the operator precautions exceed the label recommendations on the existing ground boom label.
All personnel on the job site must wash hands and face thoroughly before eating and drinking. Protective clothing, aircraft cockpit and vehicle cabs must be decontaminated regularly.
Product Specific Precautions
Read and understand the entire label before opening this product. If you have questions, call the manufacturer or obtain technical advice from the distributor or your provincial agricultural representative. Application of this specific product must meet and/or conform to the following:
Volume: Apply the recommended rate in a minimum spray volume of 50 litres per hectare.