Bumper 432 ECComparación de productos fitosanitariosComparación de productos fitosanitariosNotificar inexactitudesNotificar inexactitudes

GENERAL INFORMATION:
Introduction: BUMPER 432 EC is a broad-spectrum systemic fungicide for control of a wide range of diseases on certain crops. BUMPER 432 EC fungicide will protect the crop from yield and quality losses due to disease. BUMPER 432 EC may be used in conjunction with higher seeding rates and higher fertilizer inputs. (See “NOTE” under PRECAUTIONS).

Factors Affecting BUMPER 432 EC Performance: BUMPER 432 EC should be applied as a preventative disease control measure. Established diseases are more difficult to control and may have already reduced crop vigour.
If rainfall occurs within one hour of application, reapplication is necessary.

AERIAL APPLICATION:
DO NOT apply when wind speed is greater than 16 km/h at flying height at the site of application. High humidity and low temperatures (10 – 20°C) allow for a better deposition of spray droplets.
SPRAYER AND APPLICATION INFORMATION:
The performance of this product depends on correct application. Follow the guidelines given below for optimal application of BUMPER 432 EC.

Ground Application:
Mixing and Spraying Instructions:
• Spray equipment should be thoroughly flushed with clean water before mixing BUMPER 432 EC.
• Fill spray tank 1/2 full with clean water. Engage gentle agitation.
• Add the required amount of BUMPER® 432 EC and agitate thoroughly.
• Continue filling the tank with water until the tank is 9/10 full and, if applicable, add the required amount of tank mix partner.
• Complete filling the spray tank with water, maintaining agitation during mixing and spraying operations.
• Use nozzle screens no finer than 50 mesh. Keep by-pass line on or near the bottom of the tank to minimize foaming.

Aerial Application:
Mixing and Spraying Instructions:
• Spray equipment should be thoroughly flushed with clean water before mixing BUMPER 432 EC.
• Fill premix tank 1/2 full with clean water. Engage gentle agitation.
• Add the required amount of BUMPER 432 EC and agitate thoroughly.
• Continue filling the tank with water until the tank is 9/10 full and, if applicable, add the required amount of tank mix partner.
• Complete filling the premix tank with water.
• Maintain gentle agitation during mixing.
• Transfer the premix contents into the aircraft spray tank.
• Maintain sufficient agitation during the mixing and spraying operation to ensure
BUMPER 432 EC remains in suspension.
• Use nozzle screens no finer than 50 mesh. Keep by-pass line on or near the bottom of the tank to minimize foaming.
Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rates and conditions of this label. Label rates, conditions and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. Where no rate for aerial application appears for a specific use, this product cannot be applied by any type of aerial equipment. Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking devices.