ButtonComparación de productos fitosanitariosComparación de productos fitosanitariosNotificar inexactitudesNotificar inexactitudes

DIRECTIONS FOR USE

General Information
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
Feeding Restriction: DO NOT graze or feed treated field pea hay, field pea vines/silage, cowpea forage and cowpea hay to livestock.
DO NOT apply this product through any type of irrigation system.
DO NOT APPLY BY AIR.
Do not exceed 2.9 kg of product per hectare or 3 applications per year.
Within the stated range, apply the highest rate and the shortest interval under conditions of high disease pressures.
Make no more than two (2) sequential applications of BUTTON Fungicide before alternating with another registered fungicide with a different mode of action.

Ground Application
Field sprayer application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American
Society of Agricultural Engineers (ASAE S572.1) fine classification. Boom height must be 60 cm or less above the crop or ground.

Airblast application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT direct spray above plants to be treated. Turn off outward pointing nozzles at row ends and outer rows. DO NOT apply when wind speed is greater than 16 km/h at the application site as measured outside of the treatment area on the upwind side.
DO NOT apply by air.

Mixing Procedures
Prepare only the amount of spray mixture that is needed for the immediate operation.
Thoroughly clean spray equipment before using this product. Vigorous agitation is necessary for proper dispersal of the product. Maintain maximum agitation throughout the spraying operation.
Do not let the spray mixture stand overnight in the spray tank. Flush the spray equipment thoroughly following each use and apply the rinsate to a previously treated area.
1. Add 1/2 of the required amount of water to the mix tank.
2. With the agitator running, add the BUTTON Fungicide to the tank.
3. Continue agitation while adding the remainder of the water.
4. Begin application of the solution after the BUTTON Fungicide has completely dispersed into the mix water.
5. Maintain agitation until all of the mixture has been applied.

Spray Buffer Zones
A spray buffer zone is NOT required for uses with hand-held application equipment permitted on this label.
The spray buffer zones specified in the table below are required between the point of direct application and the closest downwind edge of sensitive freshwater habitats (such as lakes, rivers, sloughs, ponds, prairie potholes, creeks, marshes, streams, reservoirs, and wetlands) and estuarine/marine habitats.