Razor 250 SCComparación de productos fitosanitariosComparación de productos fitosanitariosNotificar inexactitudesNotificar inexactitudes

PRODUCT INFORMATION

RAZOR 250 SC is a broad spectrum, preventative fungicide with systemic properties recommended for the control of plant diseases of canola, legume vegetables including soybeans, seed corn, potatoes, tomatoes, ginseng, hazelnuts, filberts, sugarbeets, coriander, ferns of asparagus, spinach, sweet and field corn, carrots, radish, daikon, horseradish, rutabaga, turnip, garden beet, tobacco, cereals, celery and ground cherries and for the suppression of plant diseases in cabbage, cumin, caraway, and strawberry varieties. RAZOR 250 SC is to be applied as a foliar spray. Optimum disease control/suppression will be obtained by protective treatments prior to disease establishment. Refer to the specific use directions for each crop for detailed instructions on rates, application timing and technique. Do not apply RAZOR 250 SC through irrigation equipment unless specified.

APPLICATION MIXING INSTRUCTIONS:

1. Ensure that the sprayer interior is clean, then fill the spray tank with ½ the required amount of water and engage gentle agitation. Good agitation is indicated by a rippling or rolling action on the surface of the water. 2. Add any WG or DF formulation mix partners and agitate to ensure complete mixing. 3. Add RAZOR 250 SC and agitate to ensure complete mixing. 4. Add any additional SC formulation mix partners and agitate to ensure complete mixing. 5. Add any EC formulation mix partners and agitate to ensure complete mixing. 6. Fill the tank to ¾ the required amount of water. 7. Add any solution (SN or SL) formulation mix partners and agitate to ensure complete mixing. 8. Finish filling the sprayer with water, maintaining good agitation. 9. After any break in spraying operations, agitate thoroughly before spraying again. 10. Spray the pesticide suspension the same day as mixing. 11. Do not mix, load or clean spray equipment where there is a potential to contaminate wells or aquatic systems. When using chemical handling equipment to fill the sprayer, the following additional recommendations apply:  WG and DF formulations are preferentially batch mixed.  SC, SN, and SL formulations may be inducted or batch mixed.  EC formulations are preferentially batch mixed.

AERIAL APPLICATION

Apply only by fixed-wing or rotary aircraft equipment which has been functionally and operationally calibrated for the atmospheric conditions of the area and the application rates and conditions of this label. Label rates, conditions, and precautions are product specific. Read and understand the entire label before opening this product. Apply only at the rate recommended for aerial application on this label. When no rate for aerial application appears for the specific use, this product cannot be applied by any type of aerial equipment. Ensure uniform application. To avoid streaked, uneven or overlapped application, use appropriate marking technology. GPS based marking is recommended. DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply when wind speed is greater than 16 km/h at flying height at the site of application. DO NOT apply spray droplets which are smaller than the American Society of Agricultural and Biological Engineers (ASABE) medium classification. The nozzle distribution along the spray boom length MUST NOT exceed 65% of the wing or rotor span in order to reduce drift caused by turbulent wingtip vortices.

MIXING INSTRUCTIONS:

Mixing this product directly in the aircraft hopper IS NOT recommended. The use of chemical handling or managing equipment to load the hopper IS recommended. This product MAY BE inducted into a hopper which is prefilled with water or when the product and water are mixed prior to entering the hopper. This product MAY BE batch mixed and pumped into the hopper. In all cases the chemical handling equipment and hopper interior must be clean prior to use. NOTE: WG and DF formulations are preferentially batch mixed. NOTE: SC, SN, and SL formulations may be inducted or batch mixed. NOTE: EC formulations are preferentially batch mixed.