Switch 62.5 WGComparación de productos fitosanitariosComparación de productos fitosanitariosNotificar inexactitudesNotificar inexactitudes

Fungicide for control or suppression of listed diseases on listed crops.

STORAGE
To prevent contamination store this product away from food or feed.

DECONTAMINATION AND DISPOSAL
For information on disposal of unused, unwanted product, contact the manufacturer or the provincial regulatory agency. Contact the manufacturer and the provincial regulatory agency in case of a spill, and for clean up of spills.

GENERAL INFORMATION
SWITCH 62.5WG Fungicide is a broad-spectrum fungicide for the control or suppression of listed diseases.
FAILURE TO FOLLOW DIRECTIONS AND PRECAUTIONS ON THIS LABEL MAY RESULT IN CROP INJURY, POOR DISEASE CONTROL, AND/OR ILLEGAL RESIDUES.

Spray Equipment
Thorough coverage is necessary to provide good disease control. Applications using sufficient water volume to provide thorough and uniform coverage generally provide the most effective disease control.
For ground application equipment, a minimum of 200 L of water per hectare is recommended.
To avoid spray drift, do not apply when conditions favor drift beyond the target area. Avoid spray overlap, as crop injury may occur.
Equip sprayers with nozzles that provide accurate and uniform application. Calibrate sprayer before use.

GENERAL USE DIRECTIONS
As this product is not registered for the control of pests in aquatic systems, DO NOT use to control aquatic pests.
DO NOT contaminate irrigation or drinking water supplies or aquatic habitats by cleaning of equipment or disposal of wastes.
Field sprayer application: DO NOT apply during periods of dead calm. Avoid application of this product when winds are gusty. DO NOT apply with spray droplets smaller than the American Society of Agricultural Engineers (ASAE) fine classification. Boom height must be 60 cm or less above the crop or ground.
DO NOT apply by air.
DO NOT apply this product through any type of irrigation system.

Mixing Procedures
Prepare only the amount of spray mixture that is needed for the immediate operation. Thoroughly clean spray equipment before using this product. Vigorous agitation is necessary for proper dispersal of the product. Maintain maximum agitation throughout the spraying operation. Do not let the spray mixture stand overnight in the spray tank. Flush the spray equipment thoroughly following each use and apply the rinsate to a previously treated area.
1. Add 1/2 of the required amount of water to the mix tank.
2. With the agitator running, add the SWITCH 62.5WG Fungicide to the tank.
3. Continue agitation while adding the remainder of the water.
4. Begin application of the solution after the SWITCH 62.5WG Fungicide has completely dispersed into the mix water.
5. Maintain agitation until all of the mixture has been applied.

Rotational Crop Restrictions: Do not plant any other crop for a period of 30 days after harvest or crop failure unless SWITCH 62.5WG Fungicide is registered for that use.

DIRECTIONS FOR USE
Ground application only. DO NOT APPLY BY AIR.
Do not exceed 2.9 kg of product per hectare or 3 applications per year.
Apply the higher rate and shorter interval under conditions of high disease pressures.
Make no more than two (2) sequential applications of SWITCH 62.5 WG Fungicide before alternating with another registered fungicide with a different mode of action.