Bellmac Straight

Manufacturer
UPL
Category
Herbicides
Registered until
2023-09-30
Registration number
18636
Active materials
Links

A soluble concentrate formulation containing 400 g/L (34.8% w/w) MCPB present as 438 g/L (38.1% w/w) MCPB as the sodium salt for the control of broad-leaved weeds in peas.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the product label. All instructions within this section must be read carefully in order to obtain safe and
successful use of this product.

RESTRICTIONS
1. Do not roll or harrow crops within 10 days of
spraying.
2. Do not apply during cold weather or drought.
3. Do not apply during rain or if rain is expected.
4. Do not spray in windy weather and avoid drift onto broad-leaved plants outside the target area.
5. Do not apply immediately before or after sowing any crop.
6. Do not use BELLMAC STRAIGHT on peas grown for seed.
7. Do not use BELLMAC STRAIGHT on Beans, Vetches, Lucerne or Yellow Trefoil.

WEEDS CONTROLLED
BELLMAC STRAIGHT applied at 4.5 L product/ha will control those annual weeds as indicated in the weed control table.
Bellmac Straight should be applied when the crop is actively growing and is at the correct growth stage. The best results will be obtained if spraying is done while the majority of annual weeds are at the seedling stage and perennials when the flower bud is forming.

Water Volume
On peas use a rate of 200 to 400 litres of water per hectare. Use a minimum rate of 225 l/ha in dense crops, or if weed growth is dense.

Spray quality
Apply as a medium quality spray (as defined by BCPC). A spray pressure of 2-3 bar is recommended.

Timing of application
BELLMAC STRAIGHT should only be applied to peas when the crop is at the correct growth stage. Application should be made from when the crop has three nodes (three fully expanded leaves) until BEFORE the flower buds can be found enclosed in the folded terminal leaf.
Particular care should be taken when treating earlier flowering varieties to ensure that flower buds can not be detected at application. Later applications made when the flower buds are present may result in reduced yield. Crops suffering from drought stress may exhibit more visible crop damage or growth distortion.

MIXING AND SPRAYING
Apply using a conventional ground vehicle mounted/ drawn equipment. Ensure that all application equipment is clean. Add half the required volume of water and start agitation, add the required quantity of Bellmac Straight. Fill the tank to the required volume of water whilst maintaining agitation. Continuous agitation must be maintained until spraying is complete. After use, the spraying machine must be thoroughly cleaned.
Wash Equipment thoroughly with water and wetting agent or liquid detergent immediately after use. Wash out again with water, drain and allow drying. Spray out, fill with clean water and leave overnight. Spray out again before storing or using for another product. Traces of Bellmac Straight can cause harm to susceptible crops sprayed later.

CONDITIONS OF SUPPLY
All goods supplied by us are of high grade and we believe them to be suitable but (as we cannot exercise any control over their mixing or use) all conditions and
warranties, statutory or otherwise, as to the quality and fitness for any purpose of our goods are excluded, except in so far as such exclusion is prevented by law,
and no responsibility will be accepted by us for any damage or injury whatsoever arising from their storage, handling, application or use. This product is to be used only in accordance with the recommendations and instructions given on the labels provided with this pack. Use in any other circumstances is entirely at users risk.

Registered for culturesRate
Peas4.5 l