CamixPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be carefully read in order to obtain safe and successful use of this product.

RESTRICTIONS
Application must be made to healthy maize, preferably in good growing conditions, when the vegetation is dry.
Do not use during periods of frosty weather, when frost is imminent, or onto crops under stress from frost, waterlogging, insect attack or drought.
Special care should be taken to avoid damage to plants outside the target area by drift or drift onto land intended for cropping.
Some phytotoxicity may be seen after application of CAMIX®. This effect is usually transient and does not affect yield.
Consult processors before use on grain maize for processing.
Ensure spraying equipment is thoroughly washed out according to specific instructions after use. Do not allow washings-out to drain onto land intended for cropping or growing crops.

CROP SPECIFIC INFORMATION
Timing and Rates of Use
CAMIX can be applied to maize either pre or early post emergence of the crop. CAMIX should be applied to the maize crop no later than the 4 leaf stage. Refer to maximum weed growth stage limits approved.

FOLLOWING CROPS AND RECULTIVATION
Following crops:
Autumn
Winter wheat (including durum wheat), winter barley and rye grass can follow (after shallow tillage) a maize crop treated with CAMIX.
Deep ploughing (greater than 15cm) followed by cultivation is necessary before drilling oilseed rape.
Spring
Forage maize and grain maize, ryegrass, spring wheat and spring barley may be sown in the spring following application of CAMIX. Do not sow any other crop at this time.
Recultivation :
In case of maize failure after a CAMIX application, only grain and forage maize can be considered as alternative crops in the same spring (ploughing is recommended prior to reseeding to avoid slight and transitory crop effects soon after emergence).

MIXING AND SPRAYING
Preparation of the spray solution
Shake thoroughly the CAMIX container. Half fill the spray tank with clean water and begin agitation.
Add the required quantity of CAMIX to the tank and complete filling. Continue agitation until spraying is completed.

Application
Application of CAMIX will be achieved by using conventional ground spraying equipment at water volumes of 200-400 L/ha.
Do not spray CAMIX post emergence of the crop if any rainfall is expected in the next 6 hours