Cleancrop AmaizePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A suspension concentrate formulation containing 200 g/l (16.9% w/w) bromoxynil and 300 g/l (25% w/w) terbuthylazine.

RESTRICTIONS
Do not overlap spray swaths.
Do not apply with oils or other adjuvants.
Do not apply using hand held equipment or at volumes lower than those recommended.
Do not spray in windy weather as drift may damage susceptible crops such as beans, beet, brassicas (including oilseed rape) carrots, legumes, lettuce, tomato, fruit, hops, glasshouse crops, and drift onto open water surfaces.
Do not apply during frosty weather, drought, when soil is waterlogged, when rain is expected within 12 hours of spraying, or to crops under any stress whatsoever.
CLEANCROP AMAIZE should only be used where damaging weed populations of competitive weeds have emerged. In the absence of significant weed populations, use of CLEANCROP AMAIZE can reduce yield.

WEED CONTROL
CLEANCROP AMAIZE is a contact herbicide with residual action. It is not necessary to add other residual herbicides to CLEANCROP AMAIZE. CLEANCROP AMAIZE can be applied where a pre-emergence residual herbicide has been used.

RATES OF USE
1.5 L/ha in at least 200 L/ha water followed by
1.0 L/ha in at least 200 L/ha water

CROP SPECIFIC INFORMATION
Crop and timing
Spring sown forage maize may be treated with CLEANCROP AMAIZE from the 2nd fully expanded leaf stage up to before the nine fully expanded leaf stage.
Crops should be sprayed when the main weed flush has germinated and the largest weeds are at the 4 leaf stage. Applications to weeds larger than this growth stage may not be fully effective.

RATE OF APPLICATION
2.5 L/ha in at least 200 L/ha water.

SUCCEEDING CROPS
Land treated with CLEANCROP AMAIZE should be mould board ploughed to a depth of 150mm before any succeeding crop is planted. Succeeding crops may only be planted in the spring following application with CLEANCROP AMAIZE.

MIXING AND APPLICATION
Ensure that the sprayer is clean and in good working order. Calibrate according to the sprayer manufacturers recommendations.
Volume - Apply in a minimum of 200 L/ha and increase to 400 L/ha in dense crops or where weeds are at the largest growth stage.
Maintain agitation during mixing and loading and until spraying is complete.
Pressure - Do not use less than 2 bar (30 p.s.i).
Apply as a fine spray