Fielder SEPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Formulation
A suspo-emulsion containing 500 g/l chlorothalonil and 25 g/l proquinazid.

Rainfastness
Rainfall within 2 hours of application may reduce the effectiveness of the treatment.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.

Restrictions
FIELDER SE should not be applied to any crop suffering from stress as a result of drought, waterlogging, low temperatures, nutrient or lime deficiency or other factors
reducing crop growth.
Avoid application in either frosty or hot, sunny weather conditions.
Up to 2 treatments may be applied per crop, however FIELDER SE should be tank-mixed with an alternate mode of action fungicide when applied in the presence of heavy disease infestations or when applying a sequential application.
There is a possibility that some crops may suffer adverse effects from FIELDER SE, care should therefore be taken to avoid drift onto non-target crops.

Volume and Application
Apply in 200 - 300 litres/ha of water using spraying equipment to give good even coverage of the crop. The higher volumes are recommended when the crop is dense. A spray pressure of 2 – 3 Bar is recommended.

Mixing
Ensure that the sprayer is clean and correctly set to give an even application at the required volume. Half-fill the spray tank with clean water and start agitation. Shake the container and add the required amount of FIELDER SE to the sprayer using a filling device (e.g. induction bowl or closed transfer unit) or by direct addition to the sprayer tank. Wash out containers thoroughly, preferably using an integrated pressure rinsing device, or manually rinse three times. Add washings to the sprayer at the time of filling. Complete filling to the required volume and continue to agitate throughout the spraying operation. Do not leave the spray liquid in the sprayer for long periods (such as during meal breaks or overnight).

Crops
FIELDER SE can be used on all varieties of wheat and barley.

Dose
Apply FIELDER SE at 2 L/ha.

Timing
FIELDER SE can be applied at any time before full flowering (GS 65) on wheat or before first awns visible (GS 49) on barley. Up to a maximum of 2 treatments may be made. The first treatment should be applied preventatively at the onset of disease development before its spread to new growth. If a second treatment is required, this may be applied after 4 – 6 weeks and must be tankmixed with an alternate mode of action mildewicide (see Compatibility). Apply in 200 - 300 litres/ha of water using spraying equipment to give good even coverage of the crop. The higher volumes are recommended when the crop is dense. A spray pressure of 2 – 3 Bar is recommended.

Mixing
Ensure that the sprayer is clean and correctly set to give an even application at the required volume. Half-fill the spray tank with clean water and start agitation. Shake the container and add the required amount of FIELDER SE to the sprayer using a filling device (e.g. induction bowl or closed transfer unit) or by direct addition to the sprayer tank. Wash out containers thoroughly, preferably using an integrated pressure rinsing device, or manually rinse three times. Add washings to the sprayer at the time of filling. Complete filling to the required volume and continue to agitate throughout the spraying operation. Do not leave the spray liquid in the sprayer for long periods (such as during meal breaks or overnight).

Compatibility
Refer to Compatibility appendix.