Finish SXPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Formulation
A non segregating blend of water soluble granules containing 67 g/kg metsulfuron-methyl and 333 g/kg thifensulfuron-methyl, based on SX technology.

Rainfastness
Rainfast after 2 hours from application, providing  good drying conditions.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.

Restrictions
FINISH SX must not be applied to any crop suffering from stress as a result of drought, water-logging, low temperature, pest or disease attack, nutrient deficiency, soil compaction or other factors reducing plant growth.
Do not use FINISH SX on crops undersown with grasses, clover or other legumes or any other broad-leaved crop.
Because some non-target crops are highly sensitive to FINISH SX, avoid damage by drift onto broad-leaved plants outside the target area, or onto ponds, waterways or ditches. Thorough cleansing of equipment is also very important - see separate section.
Crop failure: In the event of crop failure for any reason, sow only winter wheat within three months of application of FINISH SX. Prior to sowing, soil should be ploughed and cultivated to a depth of at least 15-cm.
Do not apply within 7 days of rolling the crop.
Contract agents should be consulted before using on crops grown for seed.
Refer to ‘Compatibility’ for details on use of FINISH SX with other ‘ALS inhibiting’ herbicides.

Soil
FINISH SX can be used on all soil types. Weed control may be reduced when conditions are very dry.

Volume and application
BEFORE USING FINISH SX, SPRAYING EQUIPMENT MUST BE CLEAN AND FREE FROM CONTAMINATION WITH OTHER PESTICIDES. Application should be made in 200 litres of water per hectare using suitable ground equipment to give good spray cover of the weeds. In thick crops or dense weeds use higher volumes of water (up to 400 litres of water/ha) to ensure good spray cover of the weeds. Use a conventional field crop sprayer at a pressure of 2 - 3 bars and apply as a MEDIUM spray (as defined by BCPC). Careshould be taken not to overlap spray swaths.

Mixing
Quarter fill the spray tank with clean water, start the agitation and add the required quantity of FINISH SX directly to the tank without prior creaming. Continue agitation while topping up the tank and while spraying.

Compatibility
To widen the spectrum of activity and improve the control of some weeds, FINISH SX may be applied with other herbicides, provided each product can be applied within the label
recommendations for its use. Always add FINISH SX to the spray tank first when using in tank-mix.