Hunter

Manufacturer
Dow AgroSciences
Category
Herbicides
Registered until
2023-12-30
Registration number
12836
Active materials
Links
A suspension emulsion formulation containing 100 g/litre fluroxypyr methyl heptyl ester and 2.5 g/litre florasulam.
A post-emergence herbicide for use on all varieties of WINTER AND SPRING WHEAT, BARLEY AND OATS for the control of a range of BROAD-LEAVED WEEDS.
 
DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.
 
GENERAL INFORMATION
Hunter is mainly absorbed through the foliage of weeds. The ideal timing for application is when the weeds are small and actively growing.
 
NOTES
Do not spray when crops are under stress from cold, drought, pest damage, nutrient deficiency etc. Do not roll or harrow 7 days before or after application. Take extreme care to avoid drift onto crops and non-target plants outside the target area.
 
WEED SUSCEPTIBILITY AND MAXIMUM SIZE CONTROLLED
Weed:Cleavers~
Size Controlled:Flowering
 
Weed:Chickweed
Size Controlled:Flowering
 
Weed:Mayweed species 
Size Controlled:Flowering
 
CROPS
HUNTER can be used on all varieties of winter and spring wheat, barley and oats.
 
SOIL
HUNTER may be used on all soil types.
 
TIMING
Winter wheat, winter barley
HUNTER should be applied from 3 leaves (Zadoks 13) up to before flag leaf sheath opening stage (Zadoks 45).
Spring wheat, spring barley
HUNTER should be applied from 3 leaves (Zadoks 13) up to and including before flag leaf sheath extending stage (Zadoks 39).
Winter oats, spring oats
HUNTER should be applied from 3 leaves (Zadoks 13) up to and including the before second node detectable stage (Zadoks 31).
 
RATES OF USE
One application of up to 1.8 litres/ha in winter crops or 1.5 litres/ha in spring crops will control all susceptible emerged weeds. A split application may be applied up to a maximum total dose of 1.8 litres/ha (winter crops) or 1.5 litres/ha (spring crops) where weed germination takes place over an extended period.
 
APPLICATION
HUNTER may be applied through tractor-mounted hydraulic sprayers providing they are good working order and have been calibrated according to the manufacturers’ recommendations. Do not apply through CDA applicators.
 
WATER VOLUME
Apply HUNTER in 150 to 250 litres of water per hectare. The lower volume must only be used in open crops on small weeds.
 
FOLLOWING CROPS
Crops that can be sown in the year of treatment with HUNTER: Cereals, oilseed rape1, field beans, vegetable brassicas as transplants, grass. 1Vigour reductions may be seen in following crops of oilseed rape after a dry summer. This will be outgrown and will not result in yield loss. Crops that can be sown the calendar year following treatment with HUNTER: Cereals, oilseed rape, field beans, carrots, vegetable brassicas as transplants, grass, linseed, peas, sugar beet, potatoes, maize, clover (for use in grass/clover mixtures).
 
JOINT APPLICATION
A joint application is the use of a product in tank mixture or sequence with another product.
 
IMPORTANT NOTE: Joint applications should only be made within the label recommendations of every product in the application. Only one other product with an ALS-inhibitor mode of action may be applied to a cereal crop treated with HUNTER. However a further application of HUNTER or another product containing florasulam may also be made providing the maximum total dose of florasulam is not exceeded.
 
CROP FAILURE
In the event of a crop failure in the spring with HUNTER, only the following crops may be planted: spring wheat, spring barley, spring oats, maize or ryegrass.
 
MIXING
Half fill the spray tank with water and add the required amount of HUNTER. Fill up the spray tank, agitating continuously to ensure thorough mixing, and maintain agitation until spraying is complete. Use only clean water for mixing.
 
SPRAY QUALITY
Apply HUNTER as a MEDIUM spray as defined by the BCPC system.
 
TANK MIXTURES
Where tank mixes are used, and unless directed otherwise, the preferred order of addition of products to the spray tank is as follows: water dispersible granules, wettable powders, suspension concentrates (flowables), emulsifiable concentrates, solution concentrates. Each product should be added to the half-full sprayer and be fully dispersed before the addition of the next product.
 
TANK CLEANING
To avoid subsequent injury to crops other than cereals, all spraying equipment must be thoroughly cleaned both inside and out, using All Clear Extra spray cleaner as follows:
1. Immediately after spraying, drain tank completely. Any contamination on the outside of the spraying equipment should be removed by washing with clean water.
2. Rinse inside of tank with clean water and flush through booms and hoses using at least one tenth of the spray tank volume. Drain tank completely.
3. Half fill tank with clean water and add All Clear Extra at the recommended rate. Agitate and then briefly flush the boom and hoses with the cleaning solution. Top up with water making sure the tank is completely full and allow to stand for 15 minutes with agitation. Flush the boom and hoses and drain tank completely.
4. Nozzles and filters should be removed and cleaned separately with All Clear Extra solution containing 50 ml of All Clear Extra per 10 litres of water.
5. Rinse the tank with clean water and flush through the boom and hoses using at least one tenth of the spray tank volume. Drain tank completely.
6. For disposal of washings, follow Code of Practice for Using Plant Protection Products. Do not spray onto sensitive crop or land intended for cropping with sensitive crop.
Note: If it is not possible to drain the tank completely, step 3 must be repeated before going onto step.
 
TRADEMARK ACKNOWLEDGEMENTS
HUNTER, Broadway, Dakota, Galaxy, Hiker, Slalom, Starane, Sunrise, Vamtage and Unite are trademarks of Dow AgroSciences LLC. All other brand names are trademarks of other manufacturers for which proprietary rights may exist.
 
DOW AGROSCIENCES CONDITIONS OF SUPPLY
All goods supplied by us are of high grade and we believe them to be suitable but, as we cannot exercise control over their storage, handling, mixing or use, or the weather conditions before, during or after application which may affect the performance of the goods, all conditions and warranties, statutory or otherwise, as to the quality or fitness for any purpose of our goods are excluded. No responsibility will be accepted by us or re-sellers for any failure in performance, damage or injury whatsoever arising from their storage, handling, application or use. These conditions cannot be varied by our staff or agents whether or not they supervise or assist in the use of such goods.
Registered for culturesRateBBCH
Winter wheat1.8 l13 - 45
Winter barley1.8 l13 - 45
Winter oats1.8 l13 - 31
Spring wheat1.5 l13 - 39
Spring barley1.5 l13 - 39
Spring oats1.5 l13 - 31