IntellisPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Formulation
An emulsifiable concentrate containing 200 g/l penthiopyrad, a carboxamide fungicide.

Rainfastness
Rainfast after 1 hour from application.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.

Restrictions
INTELLIS should not be applied to any crop suffering from stress as a result of drought, waterlogging, low temperatures, nutrient or lime deficiency or other factors reducing crop growth.
Avoid application in either frosty or hot, sunny weather conditions.
Up to 2 treatments may be applied per crop.
Only apply INTELLIS in tank-mixture with other fungicides (see ‘Dose’).

Volume and Application
Apply in 200 - 300 litres/ha of water using spraying equipment to give good even coverage of the crop. The higher volumes are recommended when the crop is dense. A spray pressure of 2 – 3 Bar is recommended.

Mixing
Ensure that the sprayer is clean and correctly set to give an even application at the required volume. Half-fill the spray tank with clean water and start agitation. Shake the container and add the required amount of INTELLIS to the sprayer using a filling device (e.g. induction bowl or closed transfer unit) or by direct addition to the sprayer tank. Wash out containers thoroughly, preferably using an integrated pressure rinsing device, or manually rinse three times. Add washings to the sprayer at the time of filling. Complete filling to the required volume and continue to agitate throughout the spraying operation. Do not leave the spray liquid in the sprayer for long periods (such as during meal breaks or overnight).

Crops
INTELLIS can be used on all winter and spring crops of wheat, barley, oats, rye and triticale. It may also be applied to barley undersown with grass. Apply INTELLIS under good growing conditions with adequate soil moisture. Avoid poor growing conditions which may give less reliable results.

Dose
Apply INTELLIS at 1.5 litre per hectare. INTELLIS must always be used in mixture with another product, recommended for control of the same target disease that contains a fungicide from a different cross resistance group and is applied at a dose that will give robust control.

Timing
Best results will be achieved from applications made as a protectant treatment or in the earliest stages of disease development. INTELLIS may be applied from the beginning of stem elongation (GS 30) up to the end of flowering (GS 69) on barley, oats, wheat, rye and triticale. Up to a maximum of 2 treatments may be made. If, following a disease risk assessment or the use of appropriate decision support systems, a second treatment is required, this may be applied after 21 days.

Compatibility
Products should only be tank-mixed if each product can be applied within the label recommendations for its use. For further information contact your DuPont distributor.