JagerPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A fungicide for the control of foliar and ear disease in winter and spring wheat, durum wheat, rye, triticale and winter and spring barley.

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.
Jager is a mixture of a triazole and strobilurin fungicide recommended for control of a wide range of diseases on winter and spring wheat, durum wheat, rye, triticale and winter and spring barley

CROP SPECIFIC INFORMATION

Jager may be used on all commercial varieties of winter and spring wheat, durum wheat, rye, triticale and winter and spring barley.
Apply Jager at 1.0 litres per hectare in wheat, durum wheat, triticale and rye and 0.75 litres per hectare in barley.
The maximum total dose per crop is:- 2.0 litres per hectare per crop in wheat, durum wheat, triticale and rye and 1.5 litres per hectare per crop in barley.
Apply Jager in 100-300 litres of water per hectare. The higher spray volumes are recommended where the crop is dense or disease pressure / risk is high to ensure good penetration to the lower leaves and stem bases. Disease control maybe compromised by reducing water volumes, where good spray coverage is difficult to achieve.
A spray pressure of 2-3 bar is recommended.
Apply as a MEDIUM spray quality (as defined by BCPC).

Latest Permitted Timing
Jager may be applied at any stage before grain milky ripe stage (GS 71) in wheat, durum wheat, triticale and rye and up to beginning of anthesis (GS 61) in barley.

MIXING AND SPRAYING
Thoroughly shake the pack before use.
Add the required quantity of Jager to the half-filled spray tank with the agitation system in operation and then fill to the required level. Continue agitation at all times during spraying and stoppages until the tank is completely empty. Spray immediately after mixing.
Sprayers should be thoroughly cleaned before use, and filters and jets checked for damage and blockages.
Boom height should be adjusted to ensure even coverage of the crop, particularly at later growth stages.
The correct height is one at which the spray from alternate nozzles meets just above the crop, in dense crops, at later growth stages, higher water volumes should be used.
Spray equipment should be thoroughly cleaned with water and detergent after use.