JaspinPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A fast acting aphicide for use in field bean, broad bean, vining peas and combining peas

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be carefully read in order to obtain safe and successful use of this product.

GENERAL INFORMATION

Best results will be obtained with JASPIN by timely application, under warm and calm conditions. Ideally, sprays should be applied when chemical uptake by the plant will be at the highest, when the plants are not wilting and the spray does not dry too rapidly, for example, during the morning or evenin.
Do not let aphid colonies become established in the crop before treatment

Use in IPM Programmes.
Bees: JASPIN may be applied to crops that are in flower but care should be taken to minimse risk to bees. Avoid spraying in the heat of the day when bees are likely to be particularly active; application should be carried out in cool periods or late in the day when bee activity is low

MIXING AND SPRAYING

Ground application
Apply using a conventional field crop sprayer in not less than 200 litres of water per hectare.
Use a medium quality spray at a pressure of 2-3 bar. Use the higher water volumes for dense crops and under hot conditions (25°C or above) – refer to recommendations under Crop Specific Information.

Mixing

Half-fill the spray tank with clean water, add the required amount of JASPIN and agitate during completion of filling.
Immediately after use, clean the spray equipment thoroughly. Drain the system completely and rinse spray tank, boom and nozzles 2-3 times with clean water until the foam and all traces of the formulation have been removed.
Crops should not be re-entered until spray residues are dry.