JettanoPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A fungicide for the control of foliar diseases in barley.

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.
Jettano is a mixture of two SDHI fungicides from different chemical groups, a carboxamide and a benzamide, recommended for control of diseases on barley.

RATE OF USE
Apply Jettano at:
• 1.25 litre per hectare.
The maximum total dose is 1.25 litre per hectare.

APPLICATION
Water volume
Apply Jettano in 150-400 litres per hectare water. The higher spray volumes are recommended where the crop is dense toensure good penetration to the lower leaves and stem bases. Disease control maybe compromised by reducing water volumes, where good spray coverage is difficult to achieve.
A spray pressure of 2-3 bar is recommended.

Spray quality
Apply as a MEDIUM spray quality (as defined by BCPC).

Latest Permitted Timing
Before beginning of flowering (BBCH 59).

Mixing
Thoroughly shake the pack before use.
Add the required quantity of Jettano to the half-filled spray tank with the agitation system in operation and then fill to the required level. Continue agitation at all times during spraying and stoppages until the tank is completely empty. Spray immediately after mixing.

General
Sprayers should be thoroughly cleaned with water and detergent after use, and filters and jets checked for damage and blockages.
Boom height should be adjusted to ensure even coverage of the crop, particularly at later growth stages. The correct height is one at which the spray from alternate nozzles meets just above the crop, in dense crops, at later growth stages, higher water volumes should be used.