LeveePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be carefully read in order to obtain safe and successful use of this product.

GENERAL INFORMATION

Benzovindiflupyr is an orthosubstituted pyrazole carboxamide fungicide belonging to the sub-class of the benzonorbornenes.
Benzovindiflupyr is an SDH inhibitor (FRAC group #7 carboxamides). Benzovindiflupyr is predominantly protectant substance.
Prothioconazole is a triazole (DMI) fungicide. Prothioconazole is a systemic fungicide with protectant and curative properties.
LEVEE should be used as a protectant treatment or in the earliest stages of disease development.
Consult processor before using on crops for processing.

CROP SPECIFIC INFORMATION
Crops and growing conditions
LEVEE can be used on oats, combining peas, field beans and linseed/flax. Apply LEVEE under good growing conditions with adequate soil moisture. Avoid poor growing conditions which may give less reliable results. Effectiveness using three star drift reduction technology may be reduced.

Timing
Always inspect crops to assess disease development immediately before spraying. This product should be used as a protectant treatment or in the earliest stages of disease development following a disease risk assessment or the use of appropriate decision support systems.

Rates of use
Apply LEVEE at 1.0 litres per hectare on oats.
Apply LEVEE at 0.66 litres per hectare on pulses and linseed/flax.

MIXING AND SPRAYING
Mixing Procedure
Make sure the sprayer is set to give an even application at the correct volume. Fill the spray tank with half the required volume of water and begin agitation. Add the required amount of LEVEE to the spray tank and allow to disperse before adding any other product. Add the rest of the water and continue to agitate the mixture thoroughly. Always agitate during spraying.

Spray Volume and Application
Apply LEVEE in a recommended 100 - 400 litres of water per hectare through conventional crop spraying equipment. The higher spray volumes are recommended where the crop is dense or disease pressure/risk is high to ensure good penetration to the lower leaves and stem bases. Disease control maybe compromised by reducing water volumes, where good spray coverage is difficult to achieve.
A spray pressure of 2-3 bars is recommended. Effectiveness may be reduced using three star drift reduction technology.

After Spraying
Thoroughly wash out sprayer three times according to manufacturer’s guidelines and dispose of washing and clean containers according to DEFRA Code of Practice and local water authority guidelines.