Mohawk CSPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.
A herbicide for the control of annual grasses and broadleaved weeds in potatoes, oilseed rape, field beans, combining peas, vining peas, carrots and sugar beet.

Restrictions/Warning
Do not apply to broadcast crops.
Some transient crop bleaching may occur under certain climatic conditions and can be severe where heavy rainfall follows application. This transient crop effect is rapidly outgrown and has no effect on crop yield.
Do not use on soils that are compacted or of a poor structure which may then be liable to water logging.
Reduced levels of weed control may occur if application is made to dry cloddy seedbeds or if a prolonged dry period follows application.
Do not overlap spray swaths.
For crop safety ensure Seed is well covered with a MINIMUM of 2cm of settled soil.
Do not use on sands or very light soils. Do not use on soils with more than 10% organic matter.
Consult processors before using on crops for processing.
The safety of MOHAWK CS® to daughter tubers has not been tested. Consult the manufacturer or your advisor before using on seed crops. Contract agents should be consulted before using on crops grown for seed.
Use immediately, do not leave spray solution standing in the spray tank.

Crop specific information
It is important for crop safety that the seed is covered by a minimum of 20mm of soil. Direct-drilled crops should be harrowed across slits to cover the seed before spraying.
Where direct drilled crops are treated then ploughing and cultivating to a depth of 15cm must take place before the planting of any subsequent crop. For optimum efficacy seed-beds should be firm, level and free of clods, loose and puffy seedbeds should be consolidated before spraying.

Mixing and application
Mixing
Never prepare more spray solution than is required.
Half fill the tank with clean water and start the agitation.
To ensure thorough mixing of the product, invert the container several times before opening. Add the required quantity to the spray tank while re-circulating. Fill up the tank with water and continue agitation until spraying is completed.
When tank mixes are to be used, take due note of any instructions given as to the order of mixing. Each product should be added separately to the spray tank and fully dispersed before the addition of any further product(s).
Use immediately after mixing.
On emptying the container, rinse container thoroughly.
Add washings to sprayer at time of filling and dispose of container safely

Application
Ensure good, even spray cover of the target using a COARSE quality spray