Nimbus CS

Manufacturer
BASF
Category
Herbicides
Registered until
2026-01-30
Registration number
16573
Active materials
Links
A suspension concentrate containing 250 g/litre (22.9% w/w) metazachlor and 33.3 g/litre (3.1% w/w) clomazone.
A residual pre-emergence herbicide for the control of a range of broad leaved and grass weeds, including cleavers, in winter oilseed rape.
 
DIRECTIONS FOR USE
Restrictions/Warnings
Nimbus CS can be used on all varieties of winter oilseed rape Nimbus CS is suitable for use on all soil types as defined by Soil Texture (85) System, except sands and very light soils and soils containing more than 10% organic matter.
When Nimbus CS is applied, it is important for crop safety to ensure a good seed bed has been
established and there is physical separation of the herbicide from the seed. Ensure that the seed is well covered with soil to a depth of 20 mm. With direct drilled crops, harrow across the
slits to cover the seed before spraying.
Do not apply to cloddy seedbeds as this may reduce levels of weed control. Seedbeds must have a fine, firm tilth for optimum weed control. Loose or cloddy seedbeds must be consolidated prior to application.
Do not apply to stony soils; i.e. stones, flints or chalk readily visible on surface. On brashy and
stony soils, Nimbus CS may cause transient crop bleaching and/or reduction in crop vigour or plant stand.
Do not apply when heavy rain is forecast and do not use on waterlogged soil or soils prone to
water logging. Transient crop bleaching and/or crop thinning / reductions in crop vigour can occur if there is very wet weather after application.
Do not apply Nimbus CS to soils with a compaction layer or to poorly drained soils since damage can ocur under waterlogged conditions.
Soil moisture is required for effective weed control via root uptake. Residual control may be reduced under prolonged dry conditions.
Care should be taken to avoid overlap of spray swaths.
Extreme care should be taken to avoid damage by drift onto plants outside the target area.
DO NOT USE Nimbus CS when any of the following conditions apply:- • When crop seed has been broadcast. • The crop seed has started to germinate (i.e. 48 hours after drilling) • Crop seed is not covered with 20 mm of soil; • When heavy rain is forecast; • Dry, cloddy or open seedbeds; • Late drilled crops – as a guide these are crops drilled later than the first week in September in Northern England and Scotland and later than mid-September in the rest of the UK; • Stony soils, i.e. stones, flints or chalk are readily visible on the soil surface.
Under frosty conditions a transient scorch may occur.
To reduce the risk of movement of Nimbus CS to water:- a. On clay soils, create a fine, consolidated seedbed to slow the downward movement of water. b. Do not apply Nimbus CS to dry soil. Moist soils have fewer and smaller cracks. c. Do not apply Nimbus CS if heavy rain is forecast, wait until after the event.
 
Weed Control
Nimbus CS is taken up via cotyledons and roots. Susceptible weeds may still emerge but will lack pigmentation and therefore plant death will occur shortly afterwards. Optimum results are obtained from applications made prior to weed emergence to fine, firm and moist seedbeds.
Susceptibility of weeds to Nimbus CS
Weed:Barley, Volunteer
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-R;
 
Weed:Black-grass 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-S;
 
Weed:Chickweed, Common 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-S ;
 
Weed:Cleavers 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha- S;
 
Weed:Cranesbill, Cut-leaved 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-MR;
 
Weed:Cranesbill, Round-leaved 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha- MR;
 
Weed:Dead-nettle, Red 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-S ;
 
Weed:Forget-me-not, Field 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-S ;
 
Weed:Groundsel 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha- S;
 
Weed:Mayweed spp
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-S ;
 
Weed:Meadowgrass, Annual 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-S ;
 
Weed:Pansy, Field 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha- MR;
 
Weed:Parsley piert 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha- S;
 
Weed:Penny-cress, Field 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha- MS;
 
Weed:Poppy, Common 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha- S;
 
Weed:Shepherd‘s-purse 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-S ;
 
Weed:Speedwell, Common field 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-S ;
 
Weed:Speedwell, Ivy-leaved 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha-MS ;
 
Weed:Wheat, Volunteer 
Rate:Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
Critical Comments: Nimbus CS Pre-emergence 3.0 L/ha- MR;
 
(S = Susceptible MS = Moderately Susceptible MR = Moderately Resistant R = Resistant).
 
Resistance
Strains of some annual grasses (e.g. black-grass, wild-oats, and Italian rye-grass) have developed resistance to herbicides, which may lead to poor control. A strategy for preventing and managing such resistance should be adopted. Guidelines have been produced by the Weed Resistance Action Group (WRAG) and copies are available from the HGCA, CPA, your distributor, crop adviser or product manufacturer.
Repeated use of herbicides with the same mode of action can increase the risk of strains of weeds developing resistance to these compounds, leading to poor control. In order to minimise
the risk, a strategy for preventing and managing such resistance should be adopted. Use products with different modes of action and from different chemical groups in sequence or tank-mix, in conjunction with effective cropping rotation and cultivation techniques. In all cases
the recommended rate of use should be adhered to. Follow WRAG guidelines.
Key elements of the resistance management strategy for Nimbus CS: • Always follow WRAG guidelines for preventing and managing herbicide resistant weeds. • Maximise the use of cultural control measures wherever possible (e.g. crop rotation, ploughing, stale seedbeds, delayed drilling, etc). • Use tank mixes or sequences of effective herbicides with different modes of action within individual crops, or successive crops. • For the control of herbicide resistant grass weeds, always use Nimbus CS in sequence with other effective graminicides with different modes of action. • Monitor fields regularly and investigate the reasons for any poor control. 
 
Crops
Nimbus CS can be used on all varieties of winter sown oilseed rape.
Time of application
Nimbus CS should be applied pre emergence of the crop and has maximum effect before weed
emergence.
Application should be made before the crop seed chits, which in warm moist soils may occur within 48 hours of drilling.
Seedbeds should be moist, firm and free from clods, but also see Restrictions/Warnings section.
DO NOT USE ON BROADCAST CROPS.
Extreme care should be taken to avoid damage by drift onto plants outside the target area.
Rate of application
Apply 3.0 litres per hectare Nimbus CS in a minimum of 200 litres of water per hectare.
 
Following Crops
Following crops after normally harvested winter oilseed rape.
Any crop can follow normally harvested winter oilseed rape treated with Nimbus CS.
Prior to planting, soil should be ploughed to a minimum depth of 15cm.
 Re drilling due to crop failure
In the event of crop failure the following crops may be sown, observing any guidance given on cultivation and interval between original application and drilling of the following crop:-
Redrilling the same autumn: Winter Cereals – Drill after a minimum of 6 weeks after application following ploughing of the soil to at least 25 cm depth. Winter Field Beans – Drill after a minimum of 8 weeks after application following ploughing of the soil to at least 25 cm depth.
Redrilling the following spring:
Spring cereals, Linseed, Maize-Following a 7 month interval and after ploughing to 25 cm .
Combining peas, Field beans,Sugar beet, Potatoes- Following a 3-month interval and after ploughing to 25 cm .
 
Mixing and Spraying
Application
Apply as a MEDIUM spray, as defined by BCPC.
Nimbus CS should be applied in a minimum water volume of 200 litres/ hectare.
Mixing
Never prepare more spray solution than is required.
Fill the spray tank three quarters full with water and start the agitation.
To ensure thorough mixing of the product, invert the container several times before opening.
Add the required quantity of Nimbus CS to the spray tank while re-circulating.
Add the remainder of the water and continue agitation until spraying is completed.
On emptying the product container, rinse container thoroughly by using an integrated pressure rinsing device or manually rinsing three times. Add washings to sprayer at time of filling and dispose of container safely.
 
Sprayer cleaning
Immediately after application of Nimbus CS thoroughly clean the sprayer using clean water in accordance the guidance provided by the equipment manufacturer. Traces of the product may cause damage to susceptible crops sprayed later.
Registered for culturesRate
Winter rape3 l