Propel XproPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A fungicide for the control of stem-base, foliar and ear diseases in winter and spring barley and oats.

DIRECTIONS FOR USE

IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.
PropelXpro is a mixture of bixafen (a SDH Inhibitor), prothioconazole (a triazolinthione fungicide) and spiroxamine (a spiroketoalamine) fungicides recommended for control of a wide range of diseases on winter and spring barley and oats.

PROTECT FROM FROST
CROPS
PropelXpro may be used on all commercial varieties of winter and spring barley and oats.

RATE OF USE
Apply PropelXpro at 1.5 litre per hectare in cereals.
The maximum number of applications is two per crop.

APPLICATION
Water volume
Apply PropelXpro in 100–300 litres water per hectare. The higher spray volumes are recommended where the crop is dense or disease pressure / risk is high to ensure good penetration to the lower leaves and stem bases. Disease control may be compromised by reducing water volumes, where good spray coverage is difficult to achieve.
A spray pressure of 2–3 bar is recommended.
Effectiveness using three star drift reduction technology may be reduced.

Spray quality
Apply as a MEDIUM spray quality (as defined by BCPC).

Latest Permitted Timing
PropelXpro may be applied at any stage before grain milky ripe stage.

Mixing
Thoroughly shake the pack before use.
Add the required quantity of PropelXpro to the half-filled spray tank with the agitation system in operation and then fill to the required level.
Continue agitation at all times during spraying and stoppages until the tank is completely empty. Spray immediately after mixing.

General
Sprayers should be thoroughly cleaned with water and detergent after use, and filters and jets checked for damage and blockages.
Boom height should be adjusted to ensure even coverage of the crop, particularly at later growth stages. The correct height is one at which the spray from alternate nozzles meets just above the crop, in dense crops, at later growth stages, higher water volumes should be used.