RhinoPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A soluble concentrate containing 460g/L (40.7% w/w) flutolanil for use as a potato seed treatment for the control of black scurf and stem canker.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the product label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.

RESTRICTIONS/WARNINGS
RHINO (M14311) acts against the tuber borne inoculum of Rhizoctonia solani which independent sources have indicated is the most important source of infection. However, where the soil borne inoculum level is high, treatment of tubers with RHINO (M14311) may not give full protection against infection of stems and daughter tubers.
For best results the tubers should be clean and free from soil (less than 5% of surface). Disease under areas of soil/dust will not be exposed to spray and will not be controlled.
Seed tubers should be of good quality and vigour (free from bacterial rots, physical damage, virus infection etc), and should not be sprouted to such an extent that mechanical damage to the shoots will occur during treatment or planting.
Check with your processor before using RHINO (M14311).

DISEASE CONTROL
RHINO (M14311) is a seed potato treatment which controls stem canker and black scurf (Rhizoctonia solani) when applied to the seed prior to planting. It controls black scurf on seed tubers and protects the progeny against black scurf and stem canker.

CROPS
RHINO (M14311) can be used on seed potatoes for the seed, ware or processing market. It can be used on the seed tubers of all varieties of early, second early and main crop potatoes grown for seed, ware or processing.

TIMING
RHINO (M14311) should be applied to the seed tubers before chitting, prior to or at planting. Only apply once per batch.

APPLICATION
Apply 200 ml of RHINO(M14311) per tonne of seed potatoes. It may be diluted with up to 2.0L water per tonne of tubers to ensure good coverage of the seeds. Apply RHINO (M14311) only by canopied, hydraulic or spinning disc equipment (with or without electrostatics) mounted on a rolling conveyer or table.

MIXING
Fill the tank with half the required volume of water. Measure the appropriate amount of RHINO (M14311) into the tank and make up to the required volume of water. Agitate thoroughly before and during application.