Sherman

Manufacturer
ADAMA
Category
Herbicides
Registered until
Registration expired
Registration number
13859
Active materials
An emulsifiable concentrate containing 330 g/litre (32.3% w/w) pendimethalin.
Contains pendimethalin. May produce an allergic reaction.
For use as a herbicide in a range of agricultural and horticultural crops.
 
DIRECTIONS FOR USE
RESTRICTIONS
Resistance
Strains of black grass have developed resistance to many black-grass herbicides, this may lead to poor control. The Weed Resistance Action Group has produced guidelines on avoiding and coping with resistant black-grass. Copies of the guidelines may be obtained from the CPA, your distributor, crop adviser or product manufacturer.
Always follow WRAG guidelines for preventing and managing herbicide resistant weeds.
Maximise the use of cultural control measures wherever possible (e.g. crop rotation, ploughing, stale seedbeds, delayed drilling, etc.)
Use tank mixes or sequences of herbicides with different modes of action within individual crops.
Apply pre-emergence wherever possible. Apply any post-emergence products/mixes to small, actively growing weeds, especially where high levels of resistance are suspected and to reduce the risk of resistance development.
Monitor fields regularly and investigate reasons for poor control.
 
Seedbed/soil
Seedbed must have a fine, firm tilth.
Clods, especially if larger than 75mm diameter, may reduce the level of weed control and cause seed to be inadequately covered which could result in crop damage. Consolidate loose or cloddy seedbeds before use.
On stony or gravelly soils, crop damage could occur, particularly, if heavy rain follows treatment.
Do not use on soils prone to waterlogging.
Do not soil incorporate.
Do not disturb the soil after SHERMAN has been applied.
SHERMAN may be used on all mineral soil types except when used on Onions and Leeks.
Residual control may be reduced; under prolonged dry conditions, on soils with a high Kd factor, where organic matter exceeds 6% or where ash content is high.
Do not use on soils with more than 10% organic matter.
 
Trash and Straw
This material should either be removed or evenly incorporated by cultivation, prior to the application of SHERMAN. Organic matter in the soil, including mulches and farmyard manure, can reduce weed control.
For this reason the application of SHERMAN to soils containing in excess of 10% organic matter is not recommended. If it is suspected that the organic matter content of the surface soil has significantly increased, the land should be periodically ploughed to disperse the organic matter in a greater volume of soil.
If in doubt the organic matter content of the soil should be determined by analysis.
Emerged, transplanted or established weeds SHERMAN controls weeds as they germinate.
Emerged or established weeds will not be controlled by SHERMAN used alone. These must be controlled during seedbed/plant-bed preparation by the use of an appropriate approved herbicide.
 
Soil moisture
Although SHERMAN can be more effective than many soil-acting herbicides in dry conditions, it is essential that some soil moisture be present for SHERMAN to be activated. If application, and particularly spring application, is followed by prolonged dry conditions, weed control may be reduced.
Do not use SHERMAN on soils where surface water is likely to accumulate.
 
Post-application requirements
SHERMAN must not be soil incorporated. Do not disturb the soil by further cultivation after SHERMAN has been applied.
If soils have to be rolled after SHERMAN has been applied, take care to ensure minimum disturbance of the soil.
 
Crops
Seed should be covered with a minimum of 3.2 cms of settled soil (2.5 cms for peas).
Do not apply to stressed crops
Do not apply to undersown crops
Do not apply to protected crops
Do not undersow crops treated with Sherman.
 
Crops for processing
Please consult your processor before using SHERMAN on crops to be processed.
 
Rotation
In the event of crop failure, the land must be ploughed or thoroughly cultivated to a minimum depth of 15 cms to ensure any residues are evenly dispersed throughout the soil. The minimum intervals specified below should elapse between the application of SHERMAN and sowing of the crops listed below:
 
1. Autumn Applications
The following crops may be sown or transplanted after a minimum interval of 5 months:
Spring barley, spring wheat, maize, spring field beans, broad beans, dwarf beans, peas, Brussels sprouts, cabbage, calabrese, turnip, cauliflower, carrots, parsnips, parsley and linseed
 
2. Spring or early autumn applications
The following crops may be sown or transplanted after a minimum interval of 2 months:
Spring field beans, broad beans, dwarf beans, peas, Brussels sprouts, cabbage, calabrese, turnip, cauliflower, carrots, parsnips, parsley and linseed.
The following crops may be sown after a minimum interval of 5 months:
Any crops (except red beet, sugarbeet and spinach) may be planted or sown. A minimum interval of 12 months must elapse between application and sowing red beet, sugar beet and spinach.
Before ryegrass is drilled, after a very dry season, plough or cultivate to at least 15 cms.
 
Registered for cultures
Carrots
Onions
Leeks
Broccoli
Brussels sprouts
Cauliflower
Cabbage
Winter wheat
Winter rye
Winter triticale
Spring barley
Peas
Potatoes
Corn