SublimePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

A fungicide for the control of stem-base, foliar and ear diseases in winter and spring wheat, winter rye.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be read carefully in order to obtain safe and successful use of this product.
PROTECT FROM FROST
Sublime is a mixture of a strobilurin and a triazolinthione fungicide recommended for control of a wide range of diseases on winter and spring wheat and winter rye.

CROPS
Sublime may be used on all commercial varieties of winter and spring wheat and winter rye.

RATE OF USE
Apply SUBLIME at:
• 1.5 litres per hectare on wheat and winter rye
The maximum total dose per crop is 3.0 litres per hectare in wheat and winter rye.

APPLICATION
Water volume
Apply Sublime in 100-300 litres of water per hectare. The higher spray volumes are recommended where the crop is dense or disease pressure / risk is high to ensure good penetration to the lower leaves and stem bases. Disease control maybe compromised by reducing water volumes, where good spray coverage is difficult to achieve.

Pressure
A spray pressure of 2-3 bar is recommended.

Spray quality
Apply as a MEDIUM spray quality (as defined by BCPC).

Latest Permitted Timing
Winter and spring wheat and winter rye:
Sublime may be applied at any stage before grain milky ripe stage.

Mixing
Thoroughly shake the pack before use.
Add the required quantity of Sublime to the half-filled spray tank with the agitation system in operation and then fill to the required level. Continue agitation at all times during spraying and stoppages until the tank is completely empty. Spray immediately after mixing.

Tank washing
Any product rinsings should be added to the spray tank and sprayed on the crop to be treated.
The product can be removed from spray tanks by rinsing with water and detergent.

General
Sprayers should be thoroughly cleaned before use, and filters and jets checked for damage and blockages.
Boom height should be adjusted to ensure even coverage of the crop, particularly atlater growth stages. The correct height is one at which the spray from alternate nozzles meets just above the crop. In dense crops, at later growth stages, higher water volumes should be used.
Thoroughly wash equipment with water and detergent after use.