Tebuzol 250Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

An oil in water emulsion containing 250 g/L tebuconazole. For control of a wide range of diseases in winter and spring wheat, winter and spring barley, winter and spring oats, rye, oilseed rape, field beans and linseed.

DIRECTIONS FOR USE
IMPORTANT: This information is approved as part of the Product Label. All instructions within this section must be carefully read in order to obtain safe and successful use of this product.
For best diseases control and yield benefit TEBUZOL 250 should be applied at an early stage of disease development, before infection spreads to new crop.

RESTRICTIONS
Some speckling on wheat leaf, or reddening and scorch on oat leaves may appear following treatment. These symptoms are generally transient and have not been shown to affect the yield benefit seen from the control of the diseases.
CONSULT PROCESSORS BEFORE USING ON CROPS FOR PROCESSING.

RESISTANCE MANAGEMENT
TEBUZOL 250 contains tebuconazole a DMI fungicide. Resistance has been identified in Septoria leaf blotch (Mycosphaerella graminicola) which may seriously affect the performance of the some products. TEBUZOL 250 is not recommended for the control of this disease. For further advice on resistance management in DMIs contact your agronomist or specialist advisor, and visit the FRAG-UK website.
Tank mixtures or alternation with fungicides having a different mode of action have been shown to protect against the development of resistant forms of disease. |
The possible development of diseases resistant to TEBUZOL 250 cannot be excluded or predicted.
Where such resistant strains occur, TEBUZOL 250 is unlikely to give satisfactory control.
Strains of Light Leaf Spot resistant to azole fungicides are known to exist. To avoid development of resistance apply product protectively in response to disease forecasts. Where possible, when Light Leaf Spot is present use a fungicide with an alternative mode of action or mixes containing an alternative mode of action when targeting other diseases such as Sclerotinia at mid flowering.

MIXING AND APPLICATION
Ensure sprayers are clean and in good working order.
Half fill the spray tank with clean water and begin agitation. Add the required quantity of TEBUZOL 250. Add the remainder of the water. Continue agitation during mixing and spraying. Apply as a MEDIUM quality spray (BCPC definition) at a pressure of 2-3 bars.
Spray immediately after mixing. Where tank mixtures are used TEBUZOL 250 should be added to the spray tank last, after first dispersing the other product(s).
Empty the spraying equipment completely on the field just sprayed. Remove all filters and nozzles, scrub clean and rinse them with clean water. Put 10% clean water into the tank to cover the agitator. Operate a tank flushing system if fitted. Circulate water through the pump and controls for at least one minute. Drain sprayer, collect washings. Repeat procedure once more. Pump last washing water out through boom feed, hoses and pipes. Collect washings. Clean off the outside of the sprayer using minimum water volumes. Collect washings. Replace cleaned nozzles and filters. Collect and put all washings back into the tank and spray out on the field headland, or otherwise safely dispose of them. Ensure the sprayer systems are completely drained before storage. Store Plant Protection Equipment in a properly designated store.