2,4-DB 200Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Broadleaf Herbicide
Controls Broadleaf Weeds in Soybeans, Peanuts, Seedling and Established Alfalfa, and Seedling Birdsfoot Trefoil

DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling.
Read entire label before using this product.Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulations.

MIXING INSTRUCTIONS
2,4-DB 200 ALONE: Fill the spray tank 1/2 to 3/4 full with clean water. Begin agitation and add the recommended amount of 2,4- DB 200. Add water to the spray tank to the desired level. Maintain sufficient agitation to ensure a uniform spray mixture during application.
TANK MIXTURES: 2,4-DB 200 can be applied in tank mixture with other herbicides registered for use on approved crops. Refer to the specific crop section for rate directions and other restrictions. To apply 2,4-DB 200 in mixture with another product, fill the spray tank 1/2 to 3/4 full with clean water and begin agitation. If tankmixing with wettable powder, soluble powder, flowable or dry flowable products, add the powder or flowable product first. After the other herbicide is thoroughly mixed with water, add the recommended amount of 2,4-DB 200 and add water to the spray tank to the desired level. If tankmixing with other product types, add the 2,4-DB 200 first before adding the other product. Always mix one product in water thoroughly before adding another product or compatibility problems may occur. Never mix two products together without first mixing in water.
Maintain sufficient agitation while mixing and during application to ensure a uniform spray mixture. If spray mixture is allowed to remain without agitation for short periods of time, be sure to agitate until uniformly mixed before application.

COMPATIBILITY
Evaluate tank mixtures not listed on this label for compatibility and crop safety on a small area before applying to the entire field. 2,4-DB 200 Broadleaf Herbicide may form an insoluble precipitate in very hard water. If you expect'to mix 2,4-DB 200 with very hard water, test compatibility by mixing a small amount of 2,4-DB 200 in the proposed dilution ratios, shake and observe. A compatibility agent approved for use on growing crops such as Complete Compatibility or E-Z MIX may be tested to reduce precipitation. Whenever hard water is used to dilute 2,4-DB 200, spray immediately and do not allow spray mixture to sit overnight.

PRODUCT INFORMATION
Spray tank residues of 2,4-D or MCPA mixed with 2,4-DB 200 can cause serious crop or ornamental plant injury. A sprayer previously used to apply these chemicals must be thoroughly cleaned with alkali and water before applying 2,4-DB 200. Be sure sprayer is clean before applying 2,4-DB 200. Local conditions may affect the use of herbicides. Consult your State Agricultural Experiment Station, Farm Advisors, or Extension Weed Specialists for advice in selecting treatments from this label to best fit local conditions.
INJURY TO CROPS FROM THIS HERBICIDE MAY OCCUR. IF YOU ARE NOT PREPARED TO ACCEPT SOME DEGREE OF CROP INJURY, DO NOT USE THIS PRODUCT..
Crop varieties vary in response to 2,4-DB and some are easily injured. Apply 2,4-DB 200 only to varieties known to be tolerant to 2,4-DB. If you are uncertain concerning tolerant varieties or local use situations that may affect crop tolerance to 2,4-DB, consult your seed company, state Agricultural Extension Service or qualified crop consultant for advice.
Be sure that use of this product conforms to all applicable laws, rules, and regulations. Certain states have restrictions pertaining to application distances from susceptible crops. The applicator should become familiar with these laws, rules, or regulations and follow them exactly.