Acceleron DX-612Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Directions For Use
It is a violation of federal law to use this product in a manner inconsistent with its labeling. DO NOT apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your state or tribe, consult the agency responsible for pesticide regulation.

Product Information
Xemium 2.72 fungicide ST is a broad- spectrum fungicide that provides preventive seed and seedling protection from several seed and soilborne diseases. Make all applications according to the use directions in this label. Use the higher rates of Xemium 2.72 when disease pressure is expected to be high.

Resistance Management
Fluxapyroxad, the active ingredient of Xemium 2.72, belongs to the group of respiration inhibitors classified by the U.S. EPA and Canada PMRA as a target-site-of-action Group 7 fungicide. Because of the minimal amounts of Xemium 2.72 applied to the seed, the potential for development of resistance is low. Therefore, Xemium 2.72 seedtreatments can be followed by foliar use. Follow resistance management guidelines of foliar use fungicides containing fluxapyroxad as specified on the respective labels.

Application Instructions
For use at commercial treatment facilities. Not for use on-farm.
Apply Xemium 2.72 as a water-based mixture using standard slurry or mist-type seed treatment application equipment. The exact amount of water needed to provide the mixture or slurry rate (ml/100 kg or oz/cwt of seed) for optimum coverage is difficult to predict because weather conditions (hot or cold), seed type and surface, and equipment used all have a bearing on coverage. Consult a seed treatment specialist regarding slurry rates recommended for the crop seed to be treated with Xemium 2.72. The required amount of Xemium 2.72 must then be diluted with the specified amount of water that will provide uniform and complete coverage on the seed surface. Uniform application on seed and complete seed coverage are necessary for seed safety and best disease protection. Seed
must be of a good quality and well cleaned before treatment.
The purchaser of Xemium 2.72 fungicide ST is responsible for ensuring that all seed treated with this product are adequately dyed with a suitable color to prevent accidental use as food for man or feed for animals. Refer to 21CFR, Part 2.25. Use an EPA-approved dye or colorant that imparts an unnatural color to the seed. Any dye or colorant added to treated seed must be cleared for use under 40CFR, Part 180.900, “Exemptions from the requirement of a tolerance”. Federal regulations have established official tolerances or exemptions from tolerances for residues on food and forage crops that must not be exceeded when the product (dye or colorant) is used at specified rates. Consult the seed treatment specialist for calibration and operation procedures of the seed treatment equipment being used. Mechanical agitation is required for proper mixing of Xemium 2.72. Prepare no more mixture of Xemium 2.72 than is needed for immediate treating. Add 3/4 of the required volume of water to the mix tank. With agitation running, add the required amount of Xemium 2.72 in the tank along with other seed treatment components. Add the remaining 1/4 amount of the required volume of water. Use the mixing sequence that follows. Agitate thoroughly before and during application.