Adama BUMPER 625 ECPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS BUMPER 625 EC Fungicide contains Propiconazole, a systemic foliar fungicide with protective and curative action. BUMPER 625 EC acts as an ergosterol biosynthesis inhibitor. BUMPER 625 EC mixes readily with water. Read Directions for Use and Safety Directions before opening or using this product.

MIXING Add the required amount directly to the spray tank and mix well. Pineapples – Preplant dip: Add the required amount of BUMPER 625 EC directly to the dip and mix well. Avoid excessive contamination of the dip with organic matter.

APPLICATION Cereals: May be applied by boom spray or aircraft. Ensure complete coverage of all leaves and stems is obtained. The object of spraying is to keep the upper 2 - 3 leaves green and functioning through grain filling stage. With aircraft, as a guide, apply 10 - 20 L/ha with the lower rate being used when applications are made with a crosswind of not less than 5 knots. Use the higher rates when applying to dense crops. Wheat - Stripe Rust - susceptible varieties - apply when 10 % leaves infected. Wheat - Stripe Rust - moderately susceptible varieties - apply when 15 - 20 % leaves infected. Apricots, Plums, and other Stone Fruit: Apply by high volume (dilute) sprayer or by concentrate sprayer.

Dilute Spraying: Use a sprayer designed to apply high volumes of water up to the point of run-off and matched to the crop being sprayed. Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply sufficient water to cover the crop to the point of run-off. Avoid excessive run-off. The required water volume may be determined by applying different test volumes, using different settings on the sprayer, from industry guidelines, or expert advice. Add the amount of product specified in the Directions For Use table for each 100 L of water. Spray to the point of run-off. The required dilute spray volume will change, and the sprayer set up and operation may also need to be changed as the crop grows.

Concentrate Spraying: Use a sprayer designed and set up for concentrate spraying (that is a sprayer which applies water volumes less than those required to reach the point of run-off) and matched to the crop being sprayed. Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen water volume. Determine an appropriate dilute spray volume (See Dilute Spraying above) for the crop canopy. This is needed to calculate the concentrate mixing rate. The mixing rate for concentrate can then be calculated in the following way: EXAMPLE ONLY Dilute spray volume as determined above: For example, 1500 L/ha. Your chosen concentrate spray volume: For example, 500 L/ha. The concentration factor in this example is: 3x (ie 1500 L ÷ 500 L = 3). If the dilute label rate is 10 mL/100 L, then the concentrate rate becomes 3 x 10, that is 30 mL/100 L of concentrate spraying. The chosen spray volume, amount of product per 100 L of water, and the sprayer set up and operation may need to be changed as the crop grows. For further information on concentrate spraying, users are advised to consult relevant industry guidelines, undertake appropriate competency training, and follow industry Best Practices.

FUNGICIDE RESISTANCE WARNING BUMPER 625 EC Fungicide is a member of the DMI group of fungicides. For fungicide resistance management, BUMPER 625 EC is a Group 3 fungicide. Some naturally occurring individual fungi resistant to BUMPER 625 EC and other Group 3 fungicides may exist through normal genetic variability in any fungal population. The resistant individuals can eventually dominate the fungi population if these fungicides are used repeatedly. These resistant fungi will not be controlled by BUMPER 625 EC and other Group 3 fungicides, thus resulting in a reduction in efficacy and possible yield loss. Since the occurrence of resistant fungi is difficult to detect prior to use, Adama Australia accepts no liability for any losses that may result from the failure of BUMPER 625 EC to control resistant fungi.

COMPATIBILITY BUMPER 625 EC is compatible with many commonly used orchard sprays which include Axiom® + and some formulations of azinphos methyl, diazinon, methomyl liquid, propargite, dimethoate, copper oxychloride, mancozeb, zineb, and chlorothalonil. Mixtures with more than one of the above are not recommended.

PRECAUTIONS Re-entry Period: DO NOT enter treated area until spray has dried. PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT DO NOT contaminate streams, rivers or waterways with the chemical or used containers. PROTECTION OF LIVESTOCK Low hazard to bees. No special precautions are required.

CROP DISEASE STATE RATE WHP CRITICAL COMMENTS PER HECTARE HIGH VOLUME PER 100 L Wheat – continued Yellow Spot (Pyrenophora tritici-repentis) All States 100 - 200 mL - Harvest 4 weeks Grazing 7 days Apply once between 70 % flag leaf emergence and early flowering. Use the higher rate under high infection pressure or where longer residual protection is required. Apply after 70 % flag leaf emergence and before disease levels reach 5 % on the flag leaf. Higher rates give longer residual protection and often better economic returns.

GROUP 3 FUNGICIDE APVMA Approval No: 69815/61801 BUMPER® 625 EC Fungicide PAGE 6 OF 6

STORAGE AND DISPOSAL Store in the closed, original container in a cool, well-ventilated area. DO NOT store for prolonged periods in direct sunlight. Triple rinse containers before disposal. Add rinsings to the spray tank. DO NOT dispose of undiluted chemicals on site. If recycling, replace cap and return clean containers to recycler or a designated collection point. If not recycling, break, crush, or puncture and deliver empty packaging to an approved waste management facility. If an approved waste management facility is not available bury the empty packaging 500 mm below the surface in a disposal pit specifically marked and set up for this purpose, clear of waterways, desirable vegetation, and tree roots, in compliance with relevant Local, State or Territory government regulations. DO NOT burn empty containers or product.

Envirodrum Micro Matic Valve (110 L) Store the original sealed Envirodrum in a cool well-ventilated area. DO NOT store for prolonged periods in direct sunlight. DO NOT tamper with the Micro Matic valve or the security seal. DO NOT contaminate the Envirodrum with water or any foreign matter. After each use of the product, please ensure that the Micro Matic coupler delivery system and hoses are disconnected, triple rinsed with clean water, and drained accordingly. When the contents of the Envirodrum have been used, please return the Envirodrum to the point of purchase. The Envirodrum remains the property of Adama Australia.

1000 L Store in the closed, original container in a cool, well-ventilated area. DO NOT store for prolonged periods in direct sunlight. Storage must be secure so that contents cannot be tampered with. All locks and/or seals must be in order. If locks or seals are broken prior to initial use then the integrity of this product cannot be assured. If this occurs Adama Australia should be advised immediately. This minibulk container is reusable and remains the property of Adama Australia. DO NOT rinse empty container. Empty contents fully into application equipment. Close all valves and return to the point of supply for refill or storage. No other liquid, solid, or pesticide product should be put into it. When empty return to Adama Australia for cleaning, relabeling, and refilling.