Arctic 3.2 EC

Manufacturer
WinField
Category
Insecticides
Registered until
N/A
Registration number
1381-187
Links

RESTRICTED USE PESTICIDE
Due to Toxicity to Fish and Aquatic Organisms
For retail sale to and use only by Certified Applicators, or persons under their direct supervision, and only for those uses covered by the Certified Applicator’s certification

DIRECTIONS FOR USE
RESTRICTED USE PESTICIDE
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling.

Use Restrictions
Not for use in outdoor residential misting systems.
Use in a handheld cold or thermal fogger is prohibited.
For 4 hours following applications, do not allow any person to reenter treated areas.
Resistance Management Recommendations
ARCTIC 3.2 EC contains a Group 3 insecticide (or acaricide). Insect/mite biotypes with acquired resistance to Group 3 may eventually dominate the insect/mite population if Group 3 insecticides/acaricides are used repeatedly in the same field or in  successive years as the primary method of control for targeted species. This may result in partial or total loss of control of those species by ARCTIC 3.2 EC or other Group 3 insecticides/acaricides.
If poor performance cannot be attributed to improper application or extreme weather conditions, a resistant strain of insect may be present. If you experience difficulty with control and resistance is a reasonable cause, immediately consult your local company representative or agricultural advisor for the best alternative method of control in your area.
To delay insecticide (or acaricide) resistance consider:
x Avoiding the consecutive use of ARCTIC 3.2 EC or other group 3 insecticides/acaricides that have a similar target site of action, on the same insect/mite species.
x Using tank-mixtures or premixes with insecticides/acaricides from a different target site of action Group as long as the involved products are all registered for the same use and have different sites of action.
x Basing insecticides/acaricide use on a comprehensive IPM program.
x Monitoring treated insect/mite populations for loss of field efficacy.
x Contacting your local extension specialist, certified crop advisors, and/or Winfield Solutions, LLC representative for insecticides/acaricide resistance management and/or IPM recommendations for the specific site and resistant pest problems.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

USE INFORMATION
Important:
For advice concerning current control practices with relation to specific local conditions, consult your local State Cooperative
Extension or regulatory agencies.
ARCTIC 3.2 EC is formulated as an emulsifiable concentrate (EC) formulation and is to be diluted with water and applied as an emulsion.
For tank mixing: It is the pesticide user’s responsibility to ensure that all products in the listed mixtures are registered for the intended use. Users must follow the most restrictive directions and precautionary language of the products in the mixture (for example, first aid from one product, spray drift management from another).
ARCTIC 3.2 EC can be tank-mixed with natural pyrethrin-containing products or Insect Growth Regulators (IGRs). Do not tank mix with dichlorvos (DDVP) or other fumigant products.
Follow the most restrictive of the labeling limitations and precautions of all products used in mixtures.

APPLICATION DIRECTIONS
Follow the Directions for Use in each crop group section.
ARCTIC 3.2 EC is a 3.2 pounds per gallon formulation of the insecticide permethrin. Apply ARCTIC 3.2 EC when insects appear or feeding is noticed. The higher rate should be used as pest populations increase. Repeat the application as necessary to maintain control. Use sufficient water to obtain full coverage. With the exception of crops listed below, do not plant rotational crops within 60 days of last application.
This label must be in the possession of the user at the time of application.