AURA T+VPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

PRODUCT INFORMATION

Aura T+V formulation of Flg22-Bt peptide is a broad-spectrum activator of multiple plant defense mechanisms that suppresses plant diseases caused by bacteria and fungi. Aura T+V formulation can be applied as a foliar spray treatment to labeled crops. The level of disease control is dependent on various environmental factors, host factors, disease pressure, coverage of host plants, and method of application. INTEGRATED PEST MANAGEMENT Aura T+V should be integrated into an overall disease and pest management strategy whenever pesticides are required. Cultural practices known to reduce disease development should be followed. Consult your local agricultural authorities for IPM strategies established in your areas.

APPLICATION INSTRUCTIONS

Aura T+V may be applied by ground. Ground Foliar Application • Apply a minimum of 50 gallons of water per acre for tree and vine crops, unless otherwise specified. • Can be applied by hose-end, pressurized greenhouse, air blast mister, boom sprayer and hand-held sprayers.

MIXING AND COMPATIBILITY

Mixing Instructions • Aura T+V is a soluble liquid concentrate (SL) formulation.

• Prepare no more spray mixture than is required for the immediate operation.

• Thoroughly clean spray equipment before using this product.

• Agitate the spray solution before and during application. Aura T+V plus Tank Mixes Aura T+V is compatible with most herbicides, fungicides, bactericides, nematicides, fertilizers, nutritionals, adjuvants, and surfactants but has not been tested with all potential combinations. To ensure the physical compatibility of Aura T+V with tank mix partners, use a jar test described below. Tank Mix Compatibility Test Using a suitable container, add proportional amounts of product to water. Add wettable powders first, followed by water dispersible granules, then by liquid flowables, emulsifiable con- centrates, and lastly soluble liquid concentrates (Aura T+V) and surfactants. Mix thoroughly and let stand for at least five minutes. If the combination stays mixed or can be remixed, it is physically compatible. If the mixture balls-up, forms flakes, sludges, gels, oily film or layers, or other precipitates, it is not compatible and the tank mix combination should not be used. Mixing Procedure for Tank Mixes Step 1: Add half of the required amount of clean water to the spray or mixing tank. Step 2: With the agitator running, add tank-mix partner(s) in the following order: wettable powders, wettable granules, liquid flowables, emulsifiable concentrates, soluble liquid concentrates (Aura T+V) and surfactants. Step 3: Allow material(s) to completely dissolve and disperse into the mix water. Step 4: Fill the spray tank with the balance of water needed. Step 5: Maintain agitation until the mixture has been applied to the crop. Note: Avoid allowing spray mixture to stand overnight or for prolonged periods. No label dosage rate may be exceeded, and the most restrictive label precautions and limitations must be followed. This product may not be mixed with any product which prohibits such mixing. It is the pesticide user’s responsibility to ensure that all products are registered for the intended use. Read and follow the applicable restrictions and limitations and directions for use on all product labels involved in tank mixing. Users must follow the most restrictive directions for use and precautionary statements of each product in the tank mixture.