Azoxystrobin 9.6 STPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

USE INFORMATION
AZOXYSTROBIN 9.6% ST is a broad spectrum, preventative seed treatment fungicide with systemic properties recommended for the control of many important plant diseases. AZOXYSTROBIN 9.6% ST may be applied in tank mixes, or sequentially with other registered, crop protection products. If using AZOXYSTROBIN 9.6% ST in a tank mixture with other seed treatment products, observe all directions for use, crops/sites, use rates, dilution ratios, precautions, and limitations which appear on the tank-mix partner label. No label dosage may be exceeded and the most restrictive label precautions and limitations must be followed. This product must not be mixed with any product which prohibits such mixing.
All applications must be made according to the use directions that follow. Apply AZOXYSTROBIN 9.6% ST as a seed treatment following the guidelines specified in the Directions for Use section of this label. If a rate range is specified, use higher rates of AZOXYSTROBIN 9.6% ST when the disease pressure is expected to be
high.
It is recommended that AZOXYSTROBIN 9.6% ST be combined with a Pythium-active seed treatment such as Apron XL to offer broad spectrum protection against the seed and seedling disease complex (Rhizoctonia spp. and Pythium spp.).

RESISTANCE MANAGEMENT
AZOXYSTROBIN 9.6% ST seed treatment fungicide must be used in accordance with set guidelines for preventing build-up of resistance. When available, other registered seed treatment fungicides that have a different mode of action than strobilurins must be tank mixed with AZOXYSTROBIN 9.6% ST. However, these tank mixes must first be tested to ensure that the slurry treatment is safe on the stored or planted seed. AZOXYSTROBIN 9.6% ST is a strobilurin fungicide, therefore continuous or sequential use of a strobilurin fungicide, within or during successive growing seasons must be avoided or reduced. Consult your local or State agricultural authorities for resistance management strategies that are complementary to those in this label. AZOXYSTROBIN 9.6% ST is not cross-resistant with other classes of fungicide which have different modes of action.

MIXING INSTRUCTIONS
Apply AZOXYSTROBIN 9.6% ST as a water-based slurry using seed treatment application equipment that will provide uniform coverage on the seed surface. Consult the manufacturer of the application equipment being used for calibration and operation procedures.
AZOXYSTROBIN 9.6% ST mixes easily with water and other water-based seed treatments manufactured by Albaugh, LLC. When mixing with products from other manufacturers, the compatibility should be tested prior to use by conducting a jar test: Mix all intended seed treatments with the appropriate amount of water in a clear glass container. Mix well and allow to sit for one hour. Remix and observe for incompatibility.
Mixing AZOXYSTROBIN 9.6% ST with Tank-Mix Partners: Add ½ of the required water to the mix tank and turn on the agitation. Mechanical agitation is preferred. If using wettable powders add them first to clean water allowing them to completely disperse prior adding AZOXYSTROBIN 9.6% ST or other products. Allow each tank-mix partner to completely disperse before adding the next product. Add the remaining amount of water and agitate.
Maintain agitation until the entire slurry mixture has been used. Allow seed to dry prior to bagging.
Note: Federal law requires that bags of treated seeds shall be labeled with the following information.
• This seed has been treated with azoxystrobin seed treatment.
• Do not use treated seed for food, feed or oil purposes.
• Store treated seed away from food and feedstuffs.
• Do not allow children, pets or livestock to have access to treated seeds.
• Wear long pants, long-sleeved shirt and protective gloves when handling treated seed.
• Treated seeds exposed on soil surface may be hazardous to wildlife. Cover or collect treated seeds spilled during loading and planting.
• Dispose of all excess treated seed by burying seed away from bodies of water
• Do not contaminate bodies of water when disposing of planting equipment wash water.
• Dispose of seed packaging or containers in accordance with local requirements.