Blue Shield WP

Manufacturer
Albaugh
Category
Other
Registered until
N/A
Registration number
45002-7
Active materials
Links

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

PESTICIDE INSTRUCTIONS
Blue Shield WP may be applied by Aerial, or by Dilute or Concentrated Ground Sprayers, or Chemigation on crops and at rates given on this label unless specifically prohibited for that crop use. Sufficient spray volume and spray pressure is essential to thoroughly penetrate the plant canopy and give thorough spray coverage and at the times indicated.
On crops sensitive to copper fungicides use the higher volumes of spray water per acre. Use the higher dosage of Blue Shield WP on mature trees, or when disease pressure is severe or weather conditions warrant. When using adjuvants or other pesticides in combination with this product, always observe the most restrictive statements on the product's label and required days before harvest. Sprays of Blue Shield WP may be applied up to 24 hours pre-harvest. Before mixing with other products in spray tank, be sure that products are compatible. If compatibility is in question, use the compatibility jar test before mixing a whole tank. Blue Shield WP should not be applied in spray water having a pH of less than 6.5 as phytotoxicity may result. Use a buffering agent to increase the pH to 6.5-7.0 if your water source is below 6.5. Also avoid using water having a pH of greater than 9.0 as effectiveness may be reduced.

MIXING INSTRUCTIONS FOR SPRAY APPLICATION
Fill the spray tank one-fourth to one-third full with clean water. Start agitation (NOTE: Proper agitation creates a rippling or rolling action on the liquid surface). Add Blue Shield WP at the recommended rate.
Mix thoroughly and then add enough water to fill spray tank. Maintain sufficient agitation during mixing and during application of sprays to ensure a uniform spray mixture. When tank mixing with other products, follow the mixing sequence below: (1) micronutrients and fertilizers, (2) wettable powders, dry flowables, and water dispersible granules, (3) liquid flowables, (4) emulsifiable concentrates, and (5) adjuvants. Before adding the second pesticide, be sure that the prior product is well mixed and suspended.

Registered for cultures
Alfalfa
Almonds
Apples
Apricots
Avocados
Bananas
Beans
Carrots
Celery
Cherries
Chives
Citrus
Coffee
Cucurbits