Dicamba DMA + 2,4-D DMA SLPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Read entire label before using this product.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. Unless otherwise directed in supplemental labeling, all applicable directions, restrictions, and precautions are to be followed. Labeling must be in the user's possession during application.

PRODUCT INFORMATION
This product is a selective post-emergence herbicide for controlling a wide spectrum of annual, biennial, and perennial broadleaf weeds and brush in grass forages and selected row crops.

Mode of Action
This product contains two active ingredients: dicamba and 2,4-D. This herbicide is readily absorbed by plants through shoot and root uptake, translocates throughout the plant's system, and accumulates in areas of active growth. This product interferes with the plant's growth hormones (auxins) resulting in death of many broadleaf weeds.

Cleaning Spray Equipment
Clean application equipment thoroughly by using a strong detergent or commercial sprayer cleaner according to the manufacturer's direction and then triple rinsing the equipment before and after applying this product

APPLICATION PROCEDURES
Apply this product at the rates and growth stages listed in Tables 1 and 2 as follows, unless instructed differently in the FOOD/FEED CROP - SPECIFIC INFORMATION or NON-FOOD/FEED USE - SPECIFIC INFORMATION sections. Make applications to actively growing weeds as aerial, broadcast, band, or spot spray applications. Apply this product using water or sprayable fluid fertilizer as a carrier. Use sprayable fluid fertilizer as the carrier in preplant or pre-emergence uses for all crops listed on this label. Make post-emergence applications with sprayable fluid fertilizer on pasture, hayland, or wheat crops only.
The most effective application rate and timing varies based on the target weed species (refer to Table 1). In mixed populations of weeds the correct rate is determined by the weed species requiring the highest rate within the specified rate range. Delaying application permits weeds to exceed the maximum size stated and will prevent adequate control.

RESTRICTIONS AND LIMITATIONS
The interval between application and planting rotational crop is given below. Always exclude counting days when the ground is frozen. Planting at intervals less than specified below may result in crop injury. Moisture is essential for the degradation of this herbicide in soil. If dry weather prevails, use cultivation to allow herbicide contact with moist soil. Planting/replanting restrictions for this product for applications of 6 pints per acre or less: No rotational cropping restrictions apply at 120 days or more following application. For barley, oat, wheat, and other grass seedings, the interval between application and planting is 10 days per pint per acre. Planting/replanting restrictions for applications of more than 6 pints and up to 8 pints of this product per acre: Plant corn, soybean, sorghum, cotton (east of the Rocky Mountains) and all other crops grown in areas with 30” or more of annual rainfall 120 days or more after application. Plant barley, oat, wheat, and other grass seedings if the
interval from application to planting is 10 days per pint per acre east of the Mississippi River and 15 days per pint per acre west of the Mississippi River. For all other crops in areas with less than 30” of annual rainfall, the interval between application and planting is 180 days or more.
Rainfast period: Rainfall or irrigation occurring within 4 hours after post-emergence applications reduces the effectiveness of this product.
Stress: Do not apply to crops under stress from lack of moisture, hail damage, flooding, herbicide injury, mechanical injury, or widely fluctuating temperatures, as unsatisfactory control may result.
Do not apply to crops that show injury (leaf phytotoxicity or plant stunting) produced by any other prior herbicide applications, because this injury may be enhanced or prolonged.
Do not apply through any type of irrigation equipment. Do not contaminate irrigation ditches or water used for domestic purposes.
Do not use this product to formulate or reformulate any other pesticide product.