DoubleTakePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
Restricted Use Pesticide
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

PRODUCT INFORMATION
DoubleTake SE is a premix product containing both an insecticide and an insect growth regulator effective in the control of a wide variety of insect pests. Because it contains two modes of action, DoubleTake SE provides both quick knockdown and long residual control. Initial and residual control is contingent upon thorough coverage of the crop. Apply as a foliar spray in sufficient water to obtain full coverage of the foliage and fruit. When foliage is dense or pest pressure is high (heavier insect or egg pressure, larger instar stages), user higher application volumes and/or higher listed use rates where permitted by the label.

RESISTANCE MANAGEMENT: DoubleTake SE contains active ingredients from IRAC groups 3 and 15. Some insects are known to develop resistance to products used repeatedly for control. Because resistance development cannot be predicted, the use of this product should conform to resistance management strategies established for the use area. Consult your local or state agricultural authorities for details. Additionally, DoubleTake SE should be part of an IPM program that follows good management practices to include:
− Scouting regularly and using DoubleTake SE against early immature stages for best results
− Following the label rate and timing directions
− Maintaining good coverage of all leaf surfaces with adequate water volume
− Alternating treatments to classes of insecticides withdifferent modes of action

USE RESTRICTIONS:
Rotational Crops: Do not plant food or feed crops in DoubleTake treated soils within 1 month following last application, unless DoubleTake SE or other diflubenzuron containing products are labeled for use on the rotational crop.

APPLICATION INSTRUCTIONS
USE AND MIXING DIRECTIONS IF USED WITH WATER:
1. Fill tank with half of the required amount of water.
2. Begin agitation and add required amount of Double- Take SE.
3. Continue agitation while adding remainder of water.
4. If permitted for the use site, add proper quantity of oil slowly. To avoid formation of an invert emulsion, use at least 2 parts of water for each part of oil.
5. Continue to provide agitation while applying.

USE AND MIXING DIRECTIONS IF USED WITHOUT WATER:
Always evaluate any potential mixture for compatibility and sprayability. To ensure thorough mixing of DoubleTake SE with insecticides or other carriers, premix ingredients in a nurse tank prior to being transferred to aerial or ground ULV application equipment. If nurse tank is not available, or unable to simultaneously mix:
1. Fill tank with the required amount of oil and/or oil based insecticide.
2. Begin agitation and add required amount of DoubleTake SE.
3. After the contents of the tank have been thoroughly agitated, a volume of carrier sufficient to fill the booms and piping system should be drained and then added back to the tank.
4. Continue to provide agitation while applying.