Dyna-Shield Azoxystrobin FungicidePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INFORMATION
Dyna-Shield Azoxystrobin Fungicide is a broad spectrum, preventative seed treatment fungicide with systemic properties recommended for the control of many important plant diseases. Dyna-Shield Azoxystrobin Fungicide may be applied in tank mixes, or sequentially with other registered, crop protection products. If using Dyna-Shield Azoxystrobin Fungicide in a tank mixture with other seed treatment products, observe all directions for use, crops/sites, use rates, dilution ratios, precautions, and limitations which appear on the tank mix partner label. No label dosage should be exceeded and the most restrictive label precautions and limitations should be followed. This product should not be mixed with any product which prohibits such mixing. All applications should be made according to the use directions that follow. Dyna-Shield Azoxystrobin Fungicide may be applied as seed treatment following the guidelines in the Directions For Use section of this label. IT a rate range is specified, use higher rates of DynaShield Azoxystrobin Fungicide when the disease pressure is expected to be high.  It is recommended that Dyna-Shield Azoxystrobin Fungicide be combined with a Pythiumactive seed treatment such as Apron XL  LS to offer broad spectrum protection against the
seed and seedling disease complex (Rhizoctonia spp. and Pythium spp.).

GENERAL USE PRECAUTIONS
Do not graze or feed clippings from treated turf areas to animals. Crops in this label may be planted immediately after last treatment. Do not plant other crops within 45 days after last application.

MIXING INSTRUCTIONS
Apply Dyna Shield Azoxystrobin Fungicide as a water slurry using seed treatment application equipment that will provide uniform coverage on the seed surface. Consult the manufacturer of the application equipment being used for calibration and operation procedures.
Dyna-Shield Azoxystrobin Fungicide mixes easily with water and other water based seed treatments manufactured by Loveland Products, Inc. When mixing with product from other manufacturers the compatibility should be tested prior to use by conducting a jar test; mixing all intended seed treatments with the appropriate amount of water in a clear glass container mix well and allow to sit for one hour, remix and observe for incompatibility. Mixing Dyna-Shield Azoxystrobin Fungicide with tank mix partners: Add Y2 of the required water to the mix tank and tum on the agitation. Mechanical agitation is preferred. If using
wettable powders andlor products in water-soluble pouches, add them first to clean water allowing them to completely disperse prior to adding Dyna-Shield Azoxystrobin Fungicide or other products. Allow each tank mix partner to completely disperse before adding the next product. Add the remaining amount of water and agitate. Maintain agitation until the entire slurry mixture has been used. Allow seed to dry prior to bagging.
NOTE: Federal law requires that bags of treated seeds shall be labeled with the following information. "This seed has been treated with azoxystrobin fungicide. Do not lise for food, feed or oil purposes. Store away from food and feedstuffs." Use with an EPA approved dye that imparts an unnatural color to the seed.