Dyne-A-Pak
GENERAL INFORMATION
DYNE-A-PAK is a patented blend of deposition agents, surfactants, and activators. It is effective with herbicide products based on sulfonyl ureas.
DYNE-A-PAK improves spray application by physically modifying the deposition, wetting, and coverage of spray applications.
DIRECTIONS FOR USE
FOR USE WITH PRODUCTS REGISTERED FOR AGRICULTURAL APPLICATIONS. The addition of a spray adjuvant to some herbicides and/or fertilizers may cause
phytotoxicity to the foliage and/or fruit of susceptible crops or non-targeted vegetation. Prior to the application of DYNE-A-PAK to a spray mix, the user or applicator must have experience with the combination or must have conducted a phytotoxicity trial.
USE RATES
DYNE-A-PAK is designed to provide the spray adjuvant functions of both crop oil concentrates and surfactants when used at the rate of 4 quarts per 100 gallons of spray mixture or 1.0% by volume in ground applications. Aerial applications should use a minimum of 3-6 oz. per acre in 1-5 gallons of spray.
MIXING
(1) Prior to any herbicide application, all spray mixing and application equipment must be clean. Carefully observe all cleaning directions on the herbicide label.
(2) Fill tank 1/3 to 1/2 full of water and begin agitation.
(3) Slowly add the required amount of DYNE-A-PAK® and allow the product to completely disperse.
(4) Continue filling spray tank with water and add herbicides and/or fertilizers as directed by label or in the following sequence:
A. Fertilizers and nutrients
B. Dry flowables and dispersible granules
C. Wettable powders
D. Flowables
E. Water-soluble herbicides
F. Emulsifiable concentrates
Terminology on this label is consistent with definitions approved by Subcommittee E35.22 on Pesticide Formulations and Application Systems under the jurisdiction of ASTM Subcommittee E-35.