EjectPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

APPLICATION RATES

Dosage rates on this label indicate pints of this product per acre unless otherwise stated. Under conditions favoring disease development, the high rate specified and shortest application interval should be used. For each listed crop, the maximum total amount of active ingredient (lbs ai/A) which may be applied per acre of that crop (or crop group) during each year is listed in the Restrictions section for that crop. For each crop use situation listed below, the listed maximum individual and yearly application rates must not be exceeded, and the listed minimum retreatment intervals must not be decreased.

RESTRICTIONS

• This product must not be applied within 150 feet (for aerial and airblast applications) or 25 feet (for ground applications) from marine/estuarine water bodies unless there is an untreated buffer area of that width between the area to be treated and the water body. • Pilots must use an enclosed cab that meets the definition listed in the WPS for agricultural pesticides [40 CFR 170.305].

CROP ROTATION RESTRICTIONS

• Crops on this label may be rotated anytime following the last application of this product.

• DO NOT rotate to root and leafy vegetables for 30 days following the last application of this product.

• DO NOT rotate to winter wheat and all other crops for 120 days following the last application of this product.

MIXING INSTRUCTIONS

It is the pesticide user’s responsibility to ensure that all products are registered for the intended use. Read and follow the applicable restrictions and limitations and directions for use on all product labels involved in tank mixing. Users must follow the most restrictive directions for use and precautionary statements of each product in the tank mixture. For applications where an adjuvant will be used, use one that meets the standards of the Chemical Producers and Distributors Association (CPDA) adjuvant certification.

1. Fill the tank 1/4 to 1/3 full of water.

2. While agitating, add the required amount of this product.

3. Continue agitation until this product is fully dispersed; at least 5 minutes.

4. Once fully dispersed, maintain agitation and continue filling tank with water. Thoroughly mix this product with water before adding any other material.

5. As the tank is filling, add tankmix partner(s); then, add the necessary volume of any adjuvants, if desired. This product does not require an adjuvant. See tankmix partner labels for recommended adjuvants.

6. If the mixture is not continuously agitated, settling will occur. If settling occurs, thoroughly re-agitate before using.

7. Apply this product spray mixture within 12 hours of mixing to avoid product degradation.

8. If this product and a tankmix partner are to be applied in multiple loads, pre-slurry this product in clean water prior to adding to the tank. This will prevent the tankmix partner from interfering with the dissolution of this product.