Eminent ESPPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

PRODUCT INFORMATION
EMINENT ESP is formulated as a one pound active ingredient per gallon micro emulsion (ME). The active ingredient in EMINENT ESP is tetraconazole, a triazole fungicide (Group 3) that works by inhibiting demethylation and other processes in sterol biosynthesis. Tetraconazole is a systemic, protectant and curative fungicide and is absorbed quickly into the plant tissue. Optimal disease control is achieved when EMINENT ESP is applied in a regularly scheduled spray program.

MIXING INSTRUCTIONS
1. Fill clean spray tank 1/2 to 2/3 of desired level with clean water.
2. While agitating, slowly add the EMINENT ESP to the spray tank. Agitation should create a rippling or rolling action on the water surface.
3. If tank-mixing EMINENT ESP with other labeled pesticides, add water soluble bags first, followed by dry formulations, flowables, emulsifiable concentrates, and then solutions.
4. Adjuvants should be added to the spray solution as required.
5. Fill spray tank to desired level with water. Continue agitation until all spray solution has been applied.
6. Mix only the amount of spray solution that can be applied the day of mixing. Apply EMINENT ESP within 24 hours of mixing.

GROUND APPLICATION
Apply product in sufficient water carrier to obtain adequate coverage of all crop surfaces that are intended to be protected from disease. Increase spray volume as crop growth increases. Spray coverage is affected by nozzle type and spacing, sprayer pressure, gallonage per acre (gpa), applicator speed, and other factors. Airblast (AirAssist) Specific Recommendations: Airblast sprayers deliver the spray mixture into the canopy through a laterally directed airstream. Abide by the drift management practices when using an Airblast sprayer:
• Adjust deflectors and aiming devices so that spray is only directed into the canopy
• Block off upward pointed nozzles when there is no overhanging canopy
• Use only enough air volume to penetrate the canopy and provide good coverage
Do not allow the spray to go beyond the edge of the cultivated area (i.e. turn off sprayer when turning at end rows)
• Only spray inward, toward the field, orchard or vineyard, for applications to the outside rows.

AERIAL APPLICATION
Apply in a minimum of 5 to 10 gallons of water per acre. Do not apply under conditions when uniform coverage cannot be obtained or when excessive spray drift may occur.