Ferbam GranufloPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Only for formulation into a fungicide for the the control of certain diseases in fruit trees and berries.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.
This product may be used to formulate products for additional use(s) not listed on the MP label if the formulator, user group, or grower has complied with U.S. EPA submission requirements regarding support of such uses.

MIXING INSTRUCTIONS
Be sure equipment is clean before use; if it is contaminated with any material, crop injury or sprayer clogging may result. Calibrate spray equipment before use.
Fill the spray tank one-fourth to one-third full with· clean water. Start agitation (proper agitation creates a rippling or rolling action on the liquid surface). Slowly add Ferbam Granuflo at the recommended rate. Add water to fill spray tank. Mix thoroughly and apply at once. Maintain sufficient agitation during mixing and spraying operations to ensure a uniform spray mixture.
IMPORTANT: When spraying, thorough coverage is necessary to provide good disease control. Make new dilutions for each spraying. Consult State Agricultural Experiment Station recommendations or State Extension Service Specialist for spray schedules for timing and frequency of applications in your area.