Imidan 50-WSBPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. Not for use in residential areas.

AGRICULTURAL USE REQUIREMENTS
Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR Part 170. This Standard contains requirements for the protection of agricultural workers on farms, forests, nurseries, and greenhouses, and handlers of agricultural pesticides. It contains requirements for training, decontamination, notification, and emergency assistance. It also contains specific instructions and exceptions pertaining to the statements on this label about personal protective equipment (PPE) and restricted-entry interval. The requirements in this box only apply to uses of this product that are covered by the Worker Protection Standard.
Do not enter or allow entry into treated areas during the restricted entry interval (REI). The REI for each crop is listed in the directions for use associated with each crop. PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with anything that has been treated, such as plants, soil, or water is:
• Coveralls
• Shoes plus socks
• Chemical-resistant gloves made of any waterproof material
• Chemical-resistant headgear for overhead exposure

DILUTION DIRECTIONS
The rate required for thorough, uniform coverage varies with plant growth at time of application. Apply recommended rate in adequate spray volumes to provide complete coverage of fruit and foliage.
• For aerial applications, apply in a minimum of 2 gals. of water per acre for field and row crops, and a minimum of 5 gals. of water per acre for tree and vine crops unless otherwise specified in the recommendation for a specific crop.

MIXING DIRECTIONS
Please read and observe the following directions for use:
• Packets containing Imidan 50-WSB are water soluble. Avoid exposing inner bags to moisture .
• Do not allow bags to become wet prior to adding to the spray tank.
• Do not handle inner bag with wet hands.
• Reseal outer bag in a manner that protects remaining packets from moisture.
• To prepare the spray mixture, drop the required number of unopened packets, as determined under RECOMMENDATIONS, into the spray tank while filling with water to the desired level (whenever possible direct the fill water over the top of the packets to increase the rate of solubility). Where dosages of Imidan 50-WSB are expressed as fractions of pounds, prepare the tank mix load to the lower of the nearest whole package.
• Operate the agitator while mixing.
• Depending on the water temperature and the degree of agitation, the packets should be completely dissolved within approximately three to five minutes from the time they were added to the spray tank.
• Once the packets have completely dissolved, add other chemicals following conventional mixing order practices.
• Tank-mix solutions containing boron will affect. the solubility of the water soluble film. When preparing tank mixes containing boron, add the correct amount of Imidan 50-WSB to the spray tank first. Make sure that the water soluble packets are completely dissolved. Add boron-containing solutions to the spray tank last.

GENERAL CHEMIGATION INSTRUCTIONS
Apply this product only through one or more of the following types of systems: Sprinkler (including center pivot, lateral move, end tow, side (wheel) roll, traveler, solid set or hand move). Do not apply this product through any other type of irrigation system. Crop injury, lack of effectiveness, or illegal pesticide residues in the crop can result from nonuniform distribution of treated water. Do not connect an irrigation system (including greenhouse systems) used for pesticide application to a public water system unless the pesticide labelprescribed safety devices for public water systems are in place. If you have questions about calibration, you should contact State Extension Service speCialists, equipment manufacturers, or other experts. A person knowledgeable of the chemigation system and responsible for its operation, or under the supervision of the responsible person, shall shut the system down and make necessary adjustments should the need arise.