Induce pH
GENERAL INFORMATION
INDUCE pH is a multifunctional spray adjuvant that is applicable for use with most pesticide products. INDUCE pH is designed to quickly wet and spread a more uniform spray deposit over leaf and stem surfaces while improving deposition and adhesion. INDUCE pH also contains buffering and water conditioning agents designed to modifythe pH of spray application mixtures. INDUCE pH is recommended for use with most pesticides which are to be used with wetter/spreader type nonionic spray adjuvant.
DIRECTIONS FOR USE
The addition of an adjuvant to some pesticide tank mix combinations may cause phytotoxicity to the foliage and/or fruit of susceptible crops. Prior to the addition of INDUCE pH to spray tank mixes, the user or application advisor must have experience with the combination or must have conducted a phytotoxicity trial.
NOTE: Spray mixes of copper-containing products, such as the fungicides containing cupric hydroxide, tribasic copper or copper oxychloride, should not be buffered below a pH of 5.0.
INDUCE pH may be applied by ground, CDA, Aerial or Aquatic spray equipment. For most applications, use enough INDUCE pH to allow for uniform wetting and deposition of the spray onto leaf surfaces without undue runoff.
For use as a Nonionic Spray Adjuvant:
Ground, Aerial, CDA: Use 1-4 pints per 100 gallons of spray.
Aquatic: Use 2-4 pints per 100 gallons of spray.
NOTE: The above use recommendations are considered to be adequate for most uses. Some pesticides, however, may require higher rates for optimum effect. Follow the pesticide label directions when this occurs.
For use as Buffering and Water Conditioning Agent: To adjust the pH of spray application water for a range that is considered best for most pesticides, use 1-2 pints of INDUCE pH per 100 gallons of water.