Initiate 720Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Initiate 720 Flowable Fungicide should be used only in accordance with recommendations on this label or in separately published EPA approved supplemental labeling recommendations for this product.
Do not apply this product in a way that will contact workers or other persons, or pets, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

PRODUCT INFORMATION
Initiate 720 Flowable Fungicide is an excellent disease control agent when used according to label directions for control of a broad spectrum of plant diseases. Initiate 720 Flowable Fungicide is recommended for use in programs which are compatible with the principles of
Integrated Pest Management (IPM), which include the use of disease resistant crop varieties, cultural practices, pest scouting and disease forecasting systems which reduce unnecessary applications of pesticides. Initiate 720 Flowable Fungicide is effective for strategic use in programs that attempt to minimize disease resistance to fungicides. Some other fungicides which are at risk from disease resistance exhibit a single-site mode of fungicidal action Initiate 720 Flowable Fungicide with a multi-site mode of action, may be used to delay or prevent the development of resistance to single-site fungicides. Consult with your Federal or State Cooperative Extension Service representatives for guidance on the proper use of Initiate 720 Flowable Fungicide in programs which seek to minimize the occurrence of disease resistance to other fungicides. Initiate 720 Flowable Fungicide can be used effectively in dilute or concentrate sprays. Thorough uniform coverage is essential for disease vcontrol.

Precautions and Restrictions
DO NOT use on greenhouse-grown crops except as directed in the ORNAMENTAL PLANTS section of this label.
Do not apply when wind speed favors drift beyond the target area. Observe all spray drift precautions for ground, aerial, and chemigation applications.
Do not combine Initiate 720 Flowable Fungicide in spray tank with pesticides, surfactants or fertilizers, unless your prior use has shown the combination physically compatible, effective and noninjurous under your conditions of use. Do not combine Initiate 720 Flowable Fungicide with Dipel Latron B-1956 or Latron AG-98 as phytotoxicity may result from the combination when applied to the crops on this label.
This product must not be applied within 150 feet for aerial applications, or 25 feet for ground applications of marine/estuarine water bodies unless there is an untreated buffer area of that width between the area to be treated and the water body.

APPLICATION
Dosage rates on this label indicate pints of Initiate 720 Flowable Fungicide per acre unless otherwise stated. Under conditions favoring disease development the highest rate specified and shortest application interval should be used.
NOTE: Slowly invert container several times to assure uniform mixture.
The required amount of Initiate 720 Flowable Fungicide should be added slowly into the spray tank during filling. With concentrate sprays, pre-mix the required amount of Initiate 720 Flowable Fungicide in a clean container and add to the spray tank as it is being filled. Keep agitator running when filling spray tank and during spray operations.
Apply Initiate 720 Flowable Fungicide in sufficient water to obtain adequate coverage of foliage. Gallonage to be used will vary with crop and amount of plant growth.
For field and row crops spray volume usually will range from 20 to 150 gallons per acre for dilute sprays and 5 to 10 gallons per acre for concentrate ground sprays and aircraft applications.
For tree and orchard crops apply Initiate 720 Flowable Fungicide in sufficient water and with proper calibration to obtain uniform coverage of tree canopy. For fruit and nut bearing crops the maximum volume is 300 gallons per acre unless indicated otherwise in the specific use directions. For conifers the maximum volume is 100 gallons per acre.