Iprodione 50WP AGPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL PRECAUTIONS AND RESTRICTIONS
Use of this product at residential sites is prohibited.
Do not use IPRODIONE SOWP AG for aerial and chemigation applications.

RESTICTIONS ON CROP ROTATION: The following crops may be rotated after harvest: Beans, Broccoli, Carrots, Chinese Mustard, Cotton, Dry Onions, Garlic, Lettuce, Peanuts, Potatoes, and Rice.

RESTRICTIONS ON GRAZING FOR ALMONDS, GRAPES AND STONE FRUIT:
Livestock should not be fed cover crops found in treated orchards. Animals should not be permitted to graze in treated orchards. Contact your local extension agent with any questions regarding disease conditions. If applying this product adjacent to a water body such as a lake, reservoir, river, permanent stream, marsh or natural pond, estuary, or commercial fish pond, there must be at least a 2S-foot vegetative buffer strip between the water body and the point of application.
Do not apply this product when the wind direction is toward aquatic areas.

FUNGICIDE RESISTANCE STATEMENT
Because IPRODIONE 50WP AG is in the same dicarboximide chemical family as Ronilan, these products may contribute to resistance development if overused. As a result, under no circumstance should you exceed the number of total applications (including this product or Ronilan) permitted per crop as stated in this label. This product should not be tank-mixed with Ronilan.

HOW TO USE IPRODIONE 50WP AG
Make sure spray equipment is clean and properly calibrated before mixing IPRODIONE SOWP AG.
Fill spray-tank approximately 4 full clean water. Add labeled rate of IPRODIONE SOWP AG. Pre-mixing labeled rate in small amount of water prior to adding
to spray tank will enhance mixing process. 
Agitate mixture while adding remaining water.
Maintain agitation during application. 
Spray solution should be applied within 24 hours of preparation to avoid potential active ingredient. degradation. 
pH of spray solution should be buffered to S.O - 7.0 if necessary to minimize potential active ingrediant degradation. 
If using a spray adjuvant (not recommended for in-furrow applications), use only nonionic products, that  experience or manufacturer advice has shown to be crop tolerant. Avoid acidic products.