MCPA AminePlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

RESISTANCE MANAGEMENT RECOMMENDATIONS
MCPA Amine is a Group 4 herbicide. Any weed population may contain or develop plants naturally resistant to MCPA
Amine or other Group 4 herbicides. Weed species with acquired resistance to Group 4 may eventually dominate the weed population if Group 4 herbicides are used repeatedly in the same field or in successive years as the primary method of control for targeted species. This may result in partial or total loss of control of those species by MCPA Amine or other Group 4 herbicides.
To delay herbicide resistance consider:
x Avoiding the consecutive use of MCPA Amine or other target site of action Group 4 herbicides that have a similar target site of action, on the same weed species.
x Using tank-mixtures or premixes with herbicides from different target site of action Groups as long as the involved products are all registered for the same use, have different sites of action, and are both effective at the tank mix or prepack rate on the weed(s) of concern.
x Basing herbicide use on a comprehensive IPM program.
x Monitoring treated weed populations for loss of field efficacy.
x Contacting your local extension specialist, certified crop advisors, and/or Winfield Solutions, LLC representative for herbicide resistance management and/or integrated weed management recommendations for specific crops and resistant weed biotypes.

MIXING INSTRUCTIONS
WATER BASED SPRAY -- Fill the equipment half full of water, agitate while adding this product, then add the rest of the water.
NITROGEN FERTILIZER: Weed and feed applications for small grains, grasses grown for seed or grass pastures according to label use rates. Add half the fertilizer to the tank, then add ½ to 3/4 pint of MCPA Amine per acre. Agitate constantly and vigorously and finish filling the spray tank with fertilizer. Apply as soon as possible, agitating constantly. Do not hold spray mixture overnight. If incompatibility is a problem, the use of a compatibility agent at the specified label rate may correct the problem. Fertilize according to the recommendations of your supplier or your Extension specialist. Herbicide foliage contact burning may occur as a result of fertilizer use. Lower use rates and concentrations will reduce this problem.
Wash spray equipment thoroughly with a tank cleaner after using this product. When cleaning equipment, do not pour washwater on the ground: spray or drain over a large area away from wells or other water sources.
Note: When stored at temperatures below freezing, it may be necessary to warm contents to 700 F and mix thoroughly before using.