MCPE Phenoxy

Manufacturer
WinField
Category
Herbicides
Registered until
N/A
Registration number
1381-98
Links

DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling.
Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

USE PRECAUTIONS
Unless otherwise noted under individual DIRECTIONS section, for aerial application, apply the recommended amount in a minimum of 2 gallons of water per acre. For ground application, apply the recommended amount in a minimum of 10 gallons of water per acre. Use more water for both methods when adverse growing conditions are present. DO NOT apply with high spray pressures, hollow cone or other nozzle types that produce small spray droplets which may drift. Avoid spray
drift by making applications when conditions such as wind, air stability and temperature inversions are not a factor. The use of a suitable drift control agent at the proper rate will aid in the reduction of spray drift.
Do not apply this product through any type of irrigation system.

ROTATIONAL CROP RESTRICTION
Crops for which there are no MCPA residue tolerances established may be planted 60 days or more after application.

RESISTANCE MANAGEMENT RECOMMENDATIONS
MCPE is a Group 4 herbicide. Any weed population may contain or develop plants naturally resistant to MCPE or other Group 4 herbicides. Weed species with acquired resistance to Group 4 may eventually dominate the weed population if Group 4 herbicides are used repeatedly in the same field or in successive years as the primary method of control for targeted species. This may result in partial or total loss of control of those species by MCPE or other Group 4 herbicides.
To delay herbicide resistance consider:
x Avoiding the consecutive use of MCPE or other target site of action Group 4 herbicides that have a similar target site of action, on the same weed species.
x Using tank-mixtures or premixes with herbicides from different target site of action Groups as long as the involved products are all registered for the same use, have different sites of action, and are both effective at the tank mix or prepack rate on the weed(s) of concern.
x Basing herbicide use on a comprehensive IPM program.
x Monitoring treated weed populations for loss of field efficacy.
x Contacting your local extension specialist, certified crop advisors, and/or Winfield Solutions, LLC representative for herbicide resistance management and/or integrated weed management recommendations for specific crops and resistant weed biotypes.

MIXING INSTRUCTIONS
WATER BASED SPRAY -- Fill the equipment half full of water, agitate while adding this product, then add the rest of the water.
Wash spray equipment thoroughly with PROTANKTM cleaner after using this product. When cleaning, do not pour washwater on the ground: spray or drain over a large area away from wells or other water sources.
Consult local agricultural experiment station or extension service weed specialists for use recommendations in your area.
Note: When stored at temperatures below freezing, it may be necessary to warm contents to 700 F and mix thoroughly before using.