Muscle ADV

Manufacturer
Sipcam
Category
Fungicides
Registered until
N/A
Registration number
60063-49
Active materials
Links

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling
Do not apply this product in a way that will contact workers or other persons or pets either directly or through drift Only protected handlers may be in the area during applications For any requirements specific to your State or Tribe consult the Agency responsible for pesticide regulation

General Precautions and Restrictions
Do not use on home lawns and turf sites associated with apartment buildings daycare centers playgrounds recreational park athletic fields athletic fields located on or next to schools (IB elementary middle and high schools) campgrounds churches and theme parks
Apply only during alternate years in fields adjacent to aquatic areas such as lakes reservoirs rivers permanent streams marshes or natural ponds and estuaries This product must not be applied within 150 feet (for aerial and air blast applications) or 25 feet (for ground applications) from the aquatic areas listed above unless there is an untreated buffer area of that width between the area to be treated and the water body
Do not use in greenhouses or other enclosed areas

Mixing Loading and Applying
Muscle ADV is intended to be diluted into water and then applied to crops by typical agricultural spraying techniques Always apply this product m sufficient water to obtain thorough uniform coverage of foliage and crop surfaces intended to be protected from disease Spray volume to be used will vary with crop and amount of plant growth Spray volume should normally range from 20 to 150 gallons per acre (200 to 1400 liters per hectare) for dilute sprays and 5 to 10 gallons per acre (50 to 100 liters per hectare) for concentrate ground sprays and aircraft applications Both ground and aircraft methods of application are recommended unless specific directions are given for a crop
Slowly invert container several times to assure uniform mixture Add specified amount of this product into the mixing tank while filling with water to the desired level Keep agitator running when filling spray tank and during spray operations If other materials are added to the mixing and/or spray tank this product should be thoroughly dispersed into the water prior to the addition of other materials

Compatibility
To determine the physical compatibility of this product with other products the following procedure should be followed:

1 Pour the specified proportions of the product into a suitable container of water
2 Mix thoroughly
3 Allow to stand at least five (5) minutes
4 If the combination remains uniformly mixed or can be re mixed readily the mixture is considered physically compatible
Biological compatibility (i e effectiveness for disease control or lack of phytotoxicity) must be determined on a case by case basis Do not mix this product with any other pesticide fertilizer adjuvant or any other materials except water unless you know that such mixtures will be effective and non injurious to your crop under your conditions of use When an adjuvant is to be used with this product Sipcam Agro USA Inc recommends the use of a Chemical Producers and Distributors Association (CPDA) certified adjuvant

Registered for cultures
Cucurbits
Beans
Corn
Onions
Garlic
Shallots
Peanuts
Soybeans