NAI-1295-2Plant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
DO NOT apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

USE INFORMATION
NAI-1295-2 Herbicide/Defoliant is designed for use as a contact herbicide for control of annual or perennial herbaceous broad leaf weeds less than 4 inches in height, or rosettes less than 3 inches indiameter. Use the higher rates and spray volumes for control of larger weeds; control may be reduced with weeds larger than 4 inches. NAI-1295-2 Herbicide/Defoliant must be tank mixed with another foliar active broadleaf herbicide for complete control of most broadleaf weeds. This product requires thorough coverage for effective control.
Use an approved agriculture buffering agent, buffering to less than pH 7.5, if using NAI-1295-2 Herbicide/Defoliant in a water source greater than or equal to pH 7.5. Always buffer the water source BEFORE adding NAI-1295-2 Herbicide/Defoliant to the spray tank. Do not apply this product through any type of irrigation system. NAI-1295-2 Herbicide/Defoliant is rainfast within one hour after application.

TANK MIXTURES
NAI-1295-2 Herbicide/Defoliant may be applied as a tankmix or in sequential application with other harvest aid, fungicide, insecticide or herbicide products. Weather, crop conditions, or the presence ofcertain weeds, crop damaging insects, or diseases will indicate the inclusion of other pesticides in the defoliation or desiccation application. Apply with grass herbicides if grassy weeds are present.
Note: It is recommended that the compatibility of NAI-1295-2 Herbicide/Defoliant in any tankrriix combination be tested before use. To determine the physical compatibility with other products, use a jar test, as described below.
Using a quart jar, add the proportionate amounts of the products to 1 qt. of water. Add wettable powders and water-dispersible granular products first, then liquid flowables, and emulsifiable concentrates last. After thoroughly mixing, let stand for at least 5 minutes. If the combination remains mixed or can be remixed readily, it is physically compatible. Once compatibility has been proven, use the same procedure for adding required ingredients to the spray tank. Read and follow all label directions for each tankmix product. Always use in accordance with the most restrictive of label precautions and limitations.

MIXING DIRECTIONS
Add 1/2 to % of the required amount of water to the spray tank. Start agitation. Add the required amount of NAI-1295-2 Herbicide/Defoliant and the remaining amount of water. Mix only as much spray solution as can be sprayed within four hours. Storage and use of the previous day's spray mix may result in reduced activity.
Use an approved agriculture buffering agent, buffering to less than pH 7.5, if using NAI-1295-2 Herbicide/Defoliant in a water source greater than or equal to pH 7.5. Always buffer the water source BEFORE adding NAI-1295-2 Herbicide/Defoliant to the spray tank.