Nevado 4FPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

GENERAL INSTRUCTIONS AND INFORMATION CHEMIGATION
Apply this product only through sprinkler irrigation systems including microjet, solid set, wheel lines and center pivot. Do not apply this product through any other type of irrigation system. SPRAY PREPARATION: Remove scale, pesticide residues, and other foreign matter from the chemical tank and entire injector system. Flush with clean water.
APPLICATION INSTRUCTIONS: First prepare a suspension of Nevado 4F in a mix tank. Fill tank with Y, to % the desired amount of water. Start mechanical or hydraulic agitation. Add the required amount of Nevado 4F, and then the remaining volume of water. (Suspension concentrations using the appropriate dosage per acre recommended on this label of Nevado 4F per 1 to 4 gallons of water are recommended.) The spray solution should be buffered to a pH of 5.0-7.0. Then set sprinkler to del.iver 0.1 to 0.4 inch of water per acre. Start sprinkler and uniformly inject the suspension of Nevado 4F into the irrigation water line so as to deliver the desired rate per acre. The suspension of Nevada 4F should be injected with a positive displacement pump into the main line ahead of a right angle turn to insure adequate mixing. If you should have any other questions about calibration, you should contact State Extension Service specialists, equipment manufacturers, or other experts.
NOTE: When treatment with Nevada 4F has been completed, further field irrigation over the treated area should be avoided for 24 hours to prevent washing the chemical off the crop.