NUP-08111 FC Herbicide
DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application.
This product must be used only in accordance with instructions on this label or in separate Nufarm published instructions.
To the extent consistent with applicable law Nufarm will not be responsible for losses or damages resulting from the use of this product in any manner not specifically instructed by Nufanm. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. Do not apply this product through any type of irrigation system.
This product is a dry-flowable granule that controls many broadleaf weeds. This product is mixed in water or directly into liquid nitrogen fertilizer solutions and applied as a uniform broadcast spray. A surfactant should be used in the spray mix unless otherwise specified on this label.
Note: For definitions of portions of States recommended on this label, see listings of counties or area definitions on Crop Rotation Interval charts of this label.
This product is noncorrosive, nonflammable, nonvolatile, and does not freeze.
This product controls weeds by both preemergence and postemergence activity. For best preemergence results, apply this product before weed seeds germinate. Use sprinkler irrigation or allow rainfall to move this product 2 to 3" deep into the soil profile.
For best postemergence results, apply this product to young, actively growing weeds. The specified use rate depends upon the weed spectrum and size of weeds at time of application. The degree and duration of control may depend on the following:
• weed spectrum and infestation intensity
• weed size at application
• environmental conditions at and following treatment.
Unless otherwise prohibited on this label or the label of an intended tank mix product, this product may be applied in combination with any pesticide registered for the same crop, timing, and method of application. Observe the most restrictive label statements of various tank mix products used.
IMPORTANT: PESTICIDE TANK MIXES MAY INCREASE THE RISK OF MIXING INCOMPATIBILITIES, REDUCED EFFECTIVENESS AND/OR CAUSE CROP INJURY OR LOSS. ANY LIABILITY FOR LOSS, INJURY OR DAMAGE RESULTING FROM A TANK MIXTURE NOT SPECIFIED ON THIS LABEL OR IN MANUFACTURER'S SUPPLEMENTAL LABELING DISTRIBUTED FOR this product IS SPECIFICALLY DISCLAIMED BY MANUFACTURER.
Before full-scale mixing of this product with other pestiCides, fertilizers, secondary plant nutrients, adjuvants, surfactants or oils, you must determine the compatibility of the proposed mixture. Use proportionate quantities of each ingredient and mix in a small container. Always mix one product thoroughly with the diluent before adding another product. If no incompatibility is evident after 30 minutes, the mixture is generally compatible for spraying. To evaluate potential short term effects of applying the mixture, test the tank mix combination on a fewplants or a small area before larger-scale treatments. Wait at least 2 to 3 days for problems to become apparent.
IMPORTANT: MIXING WITH OTHER SUBSTANCES MAY INCREASE THE RISK OF MIXING INCOMPATIBILITIES, REDUCED EFFECTIVENESS AND/OR CAUSE CROP INJURY OR LOSS. ANY LIABILITY FOR LOSS, INJURY OR DAMAGE RESULTING FROM A MIXTURE NOT SPEOFIED ON THIS LABEL OR IN MANUFACTURER'S SUPPLEMENTAL LABELING DISTRIBUTED FOR this product IS SPECIFICALLY DISCLAIMED BY MANUFACfURER.
|Registered for cultures|