NUP 08136
- Manufacturer
- NUFARM
- Category
- Herbicides
- Registered until
- N/A
- Registration number
- 228-600
- Active materials
- metsulfuron-methyl0 lb/gallon
- chlorsulfuron0 lb/gallon
- Links
- LabelView
DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.
RESISTANCE MANAGEMENT
Any weed population may contain or develop plants naturally resistant to herbicides with the same mode of action. These resistant biotypes may dominate the weed population if herbicides with the same mode of action are used repeatedly in the same field, and adequate control of these resistant weeds cannot be expected. Should an application not control the target weeds, retreat the area using an herbicide with a different mode of action.
To delay herbicide resistance, follow resistance management strategies such as:
• Rotate the use of NUP-08136 with herbicides having different modes of action to treat the same weeds.
• Apply tank mixtures of herbicides with different modes of action, when such use is permitted.
• Use herbicides as part of an IPM program.
• Prevent movement of resistant weed seeds to other fields by cleaning harvesting and tillage equipment, and planting clean seed.
• Consult your agricultural dealer, consultant, applicator, and/or appropriate state agricultural extension specialist for specific alternative cultural practices or herbicide recommendations available in your area.
APPLICATION DIRECTIONS FOR WHEAT AND BARLEY
Apply 0.125 ounces NUP-08136 per acre to wheat and barley to control or suppress broad leaf weeds that are actively growing and are no more than 4 inches in height or in diameter. Crop injury may occur if applications are made during boot and early heading. To prevent reduced weed control, do not apply if rainfall is expected within 4 hours of application. For irrigated wheat and barley, apply when the crop begins tillering but prior to boot. Delay the initial irrigation until at least 3 days after application. Keep this irrigation to less than 1 inch of water.
For dryland wheat and barley, apply when the crop has reached the 2-leaf stage but prior to boot. Make a single application per use season at a rate of 0.125 ounces NUP-08136 per acre.
Registered for cultures |
---|
Winter wheat |
Spring wheat |
Spring barley |
Winter barley |