PGR-IV/BP FoliarPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

For Use On Row Crops (Cotton, Field Corn, Milo, Soybeans, Winter Wheat, Oats, Barley, Rye, Peanuts, Rice), Vegetable Crops (Peppers, Beans [green, lima, pinto, black-eyed, mung, etc.], Cabbage, Broccoli, Cauliflower, Brussels Sprouts, Cucumbers, Squash, Sweet Corn, Tomatoes, Cantaloupes, Watermelon, and Honeydew

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. When exposed to potentially high coneentrations of living microbial products such as this, all mixer/loaders and other handlers must wear a NIOSH accepted filtering face piece respirator N-95 or higher.

COMPATIBILITY
PGR-IV/BP01 PGR-IV/BP01is compatible with most insecticides, fungicides and miticides. If compatibility is in doubt, perform a standard jar test (mix all ingredients in a clear glass jar in approximate ratios intended for field application) to check for compatibility. PGR-IV/BP01 Foliar can be used with foliar fertilizers if your prior experience shows the combination is compatible and will not injure cotton under your conditions. Care should be used when applying with foliar fertilizers under conditions of extreme heat or crop stress. NOTE: Tank mixes with 2,4-0-B or other hormone type herbicides may result in unwanted additional herbicidal activity.

RESTRICTIONS AND LIMITATIONS
Do not exceed a total of 1 % oz. of PGR-IV/BP01 Foliar per acre per season. Do not apply PGR-IV/BP01 Foliar within 30 days of harvest.

SPRAY MIX VOLUMES
Refer to COMPATIBILITY section for tank mixing with other products. Use the enclosed PGR-IV/BP01 measuring cone to measure out the appropriate amount of PGR-IV/BP01 to be added to each tank. The following table gives the minimum and maximum amounts of diluent to be used to apply the amount of PGR-IV/BP01 Foliar per acre specified in the use rate tables. Applicators should use a dilution rate that achieves thorough coverage of available plant folage up to the point of runoff .